Healthrider HREL50020 manual Center the Arm Axle, Wire Harnesses, 25, 99 do not, Get pinched

9.While another person holds the Upright (2) near the Frame (1), connect the Wire Harness (25) to the Extension Harness (99). Attach the Upright to the Frame with three M10 x 25mm Screws (100) and three M10 Split Washers (13). Be careful to avoid pinching the Wire Harnesses.

10.Slide the Left Upper Body Arm (15), which is marked with an “L” sticker, onto the Chrome Tube (98) on the Left Pedal Arm (not shown). Slide the Right Upper Body Arm (18) onto the Chrome Tube on the Right Pedal Arm (4). Make sure that the Upper Body Arms are on the correct sides—the upper ends will bend in the direction shown by the arrows. Next, slide an Axle Cover (49) onto the post on each Upper Body Arm.

Apply grease to the Arm Axle (34). Insert the Arm Axle into the Upright (2), the right Pivot Cover (49), and the Right Upper Body Arm (18) as shown. Push the Arm Axle into the Upright until the left end of the Arm Axle is flush with the left side of the Upright. Next, raise the Left Upper Body Arm (15) and insert the Arm Axle into the left Axle Cover (49) and the Left Upper Body Arm.

Center the Arm Axle.

11.Push an Axle Cap (51) onto the left Axle Cover (49). Orient the Left Handlebar (104) as shown. Slide the Left Handlebar onto the indicated post and the Arm Axle (34). Attach the Left Handlebar with three M8 x 40mm Button Bolts (101) and three M8 Nylon Locknuts (80).

Attach the Right Handlebar (105) in the same way.

9			Make sure the
2	13	100	Wire Harnesses
			(25, 99) do not
13			get pinched and
			damaged during
100	13
			this step.
		99
25		1
10
			49
		2
15	34		18
	49
		Grease
	Post
			98
			4
		98
11	Post
101
104			105
	80
		34
	51
101		80	15

12.Make sure that all parts of the elliptical crosstrainer are properly tightened. Note: Some hardware may be left over after assembly is completed. To protect the floor or carpet from damage, place a mat under the elliptical crosstrainer.

8