5.Apply a small amount of grease to the axle on the Left Crank Arm (34).
Identify the Left Pedal Leg (4), which is marked with an “L” sticker. Slide the Left Pedal Leg onto the axle on the Left Crank Arm (34). (Note: It may be helpful to use a rubber mallet to tap the Left Pedal Leg on. Do not confuse the Left Pedal Leg with the Right Pedal Leg [not shown].) Attach the Left Pedal Leg with an M8 x 19mm Patch Screw (111), an M8 Washer (66), and a Torque Washer (113).
Attach the Right Pedal Leg (not shown) in the same way.
See the inset drawing. Identify the Left Pedal (10), which is marked with an “L” sticker. Attach the Left Pedal to the Left Pedal Leg (4) with two M6 x 48mm Flat Head Screws (83). Note: The Left Pedal can be attached in any of three positions using the three sets of holes in the Left Pedal Leg.
Attach the Right Pedal (not shown) to the Right Pedal Leg (not shown) in the same way.
6.Hold a Pedal Wheel (28) inside of the bracket on one of the Upper Body Legs (31). Hold the Upper Body Leg and the Pedal Wheel inside of the bracket on the Left Pedal Leg (4). Slide a Pedal Leg Cover (33) onto the long side of an M8 x 63mm Bolt Set (65), and insert the Bolt Set into the Left Pedal Leg, the Upper Body Leg, and the Pedal Wheel.
Slide a Pedal Leg Cover (33) onto the short side of the M8 x 63mm Bolt Set (65) and tighten it into the long side of the Bolt Set.
Attach the other Upper Body Leg (not shown) and the other Pedal Wheel (not shown) to the other side of the elliptical exerciser in the same way.
5 |
|
|
| Grease | 34 |
| 4 |
|
| 113 |
|
111 | 66 |
|
| 83 |
|
| 10 |
|
| 4 |
|
6 |
|
|
| 31 |
|
|
| 65 |
|
| 33 |
| 4 |
|
| 33 |
|
| 65 |
|
| 28 |
|
7