JVC LVT1040-003A manual Connecting the Speakers SP-FSX1/SP-FSX3

Page 10

Getting Started

Connecting the Speakers (SP-FSX1/SP-FSX3)

These speakers are exclusively for this system. Using with other devices will damage the speakers. Connect the speaker cords between the speaker terminals of the Unit and those of the Speakers.

When inserting the speaker wire lead, open the speaker terminal.

Connect the black cord to the ( - ) terminal and the cord without a black line to the (+) terminal.

Right side (rear view)

Left side (rear view)

BLACK

BLACK

SP-FSX1

SP-FSX1

BLACK

BLACK

SPEAKER terminal description

(on the side panel)

SP-FSX3 BLACK

BLACK SP-FSX3

BLACK

BLACK

SPEAKER terminal description

(on the side panel)

Since both speakers are the same, you can put either one to the right or left side.

Do not connect other speakers to the Unit. The difference of the load impedance causes failures.

Do not use the supplied speakers in parallel with other speakers.

CAUTION:

A TV may display irregular colors if located near the speakers. If this happens, set the speak- ers away from the TV.

7

Image 10
Contents FS-X1/FS-X3 Important for Laser Products Above ALL Introduction FeaturesHow This Manual Is Organized Table of Contents Troubleshooting Care And Maintenance Specifications Using the Remote Control AccessoriesHow To Put Batteries In the Remote Control Getting StartedUsing the Supplied Wire Antenna Connecting the FM AntennaUsing the Coaxial Type Connector Not Supplied Connecting the AM MW Antenna Connecting the Speakers SP-FSX1/SP-FSX3 When removing Connecting a Powered SubwooferConnecting an External Equipment When attaching the speaker grillsConnecting an MD Recorder, etc Optical Digital Output Automatic Power OnBasic Operations Turning the Power On and OffChanging the Source Adjusting the Volume Adjusting the Brightness Dimmer at Power OnPower Saving Mode Dimmer at Power Off Fade-out Muting Fade MutingAuto Power Off A.P.off No signal conditionTo disable the A.P.off function Entering the Number with the Remote Control Numeric KeysSelect a station using one of the follow- ing methods Using the TunerTuning In a Station One Touch RadioTo change the preset stations, repeat the same Presetting StationsTo Change the FM Reception Mode Beat Cut AM MW ReceptionTo search for a program by PTY codes Receiving FM Stations with RDSPress the PTY Search button within approx seconds again Affairs AlarmNews InfoAlarm function Test functionTo Insert a CD Using the CD PlayerWhen playing a CD-R or CD-RW Quickest Way To Start a CD Is With the One Touch OperationTo Unload a CD Basics of Using the CD Player Normal PlayProgramming the Playing Order of the Tracks Program Play Random Play Press the CD 6button on the Remote ControlTo Modify the Program Repeat to program the other tracksUnlocking the CD door Repeating TracksLocking the CD door Turn off the systemChanging the Equipment’s Name Using External EquipmentsListening to External Equipment To exit the source LINE, select other source e.g. CDPress the SET button to finish the adjustment Adjusting the Input LevelWhen the source is LINE, press and hold the SET button Recording the System’s Source to External EquipmentPress the CLOCK/TIMER button Using the TimersSetting the Clock Press the 3 or 2 button to set the hourShowing the Clock Display Setting the Daily TimerPerform steps 2 to 5 in Setting the Clo- ck on Correcting the ClockSetting the OFF time Example Setting the on time ExampleSelecting the music source Press the Cancel button Turning the Daily Timer On and OffSetting the volume level Select the Fade functionDuring playback a source, press the Sleep button Setting the Sleep TimerTimer Priority Wait for a few secondsPossible Cause TroubleshootingSymptom ActionCare And Maintenance Specifications 0403MNMCREJEM