Spalding M6711041 manual Align dimple of top pole into trough

2. Identify pole sections.

4

5

Identification Sticker

6

3. While maintaining alignment, bounce middle pole section (5) into top section (4) using a wood scrap as

shown until the top pole no longer moves toward the pole identification sticker on the middle pole.

IMPORTANT!		CAUTION!
		THE IDENTIFICATION STICKER IS
		LOCATED 5" FROM THE END OF
Align dimple of top pole section (4) into trough of		THE POLE. WHEN PROPERLY
		POUNDED TOGETHER, THE
middle pole section (5) as shown.		POLE SECTIONS SHOULD HAVE
		A 3-1/2" MINIMUM OVERLAP,
		LEAVING 1-1/2" BETWEEN THE
pole em	ID	OVERLAPPING POLE AND THE
	STICKER	IDENTIFICATION STICKER.
5"		5
	pole middle
	1-1/2"
	DIMPLE	4
	HOLE	WOOD SCRAP
		(NOT SUPPLIED)

13 02/07 ID# M6711041