Schwinn 120 manual Console displays E2 error code Check data cable integrity

Console displays "E2" error code	Check data cable integrity	All wires in cable should be intact. If any
		are cut or crimped, replace cable.
	Check data cable	Insure cable is connected securely
	connections/orientation	and oriented properly. Small latch on
		connector should line up and snap into
		place.
	Console Electronics	If tests reveal no other issues, Console
		should be replaced.
No speed/RPM reading, Console displays	Check data cable integrity	All wires in cable should be intact. If any
"E3" error code		are cut or crimped, replace cable.
	Check data cable	Insure cable is connected securely
	connections/orientation	and oriented properly. Small latch on
		connector should line up and snap into
		place.

Check magnet position (requires shroud removal)

Magnet should be in place on flywheel. If no magnet is present, replace the flywheel or the entire base unit (if unable to replace flywheel).

Check RPM Sensor (requires shroud removal)

RPM sensor should be aligned with magnet and connected to data cable. Realign sensor if necessary. Replace if there is any damage to the sensor or the connecting wire.

Console shuts off (enters sleep mode)	Check data cable integrity	All wires in the cable should be intact. If
while in use		any are cut or crimped, replace cable.
	Check data cable	Insure cable is connected securely
	connections/orientation	and oriented properly. Small latch on
		connector should line up and snap into
		place.

Reset Machine (if equipped with reset button)

Unplug unit from electrical outlet for 3 minutes. Reconnect to outlet. After the Console powers up, press "reset".

Check magnet position (Technician only- requires shroud removal)

Magnet should be in place on flywheel. If no magnet is present, replace flywheel or entire base unit.

	Check RPM Sensor	Contact Customer Care for further
		assistance.
Fan (if equipped) will not turn on or will	Check data cable integrity	All wires in cable should be intact. If any
not turn off		are cut or crimped, replace cable.
	Check data cable	Insure cable is connected securely
	connections/orientation	and oriented properly. Small latch on
		connector should line up and snap into
		place.

Reset Machine (if equipped with reset button)

Unplug unit from electrical outlet for 3 minutes. Reconnect to outlet. After Console powers up, press "reset".

Unit rocks/does not sit level	Check leveler adjustment	Leveling feet may be turned in or out to
		level bike.
	Check surface under unit	Adjustment may not be able to
		compensate for extremely uneven
		surfaces. Move bike to level area.

18