Sears 831.23953.1 user manual Tip Avoid pinching the Main Wire 42. Slide, Avoid pinching Main Wire

4. Tip: Avoid pinching the Main Wire (42). Slide

the Upright (2) onto the Frame (1).

4

Have a second person hold the Shield Cover (37) out of the way.

Attach the Upright (2) with five M10 x 20mm Screws (79) and five M10 Split Washers (78).

Tip: Start all the Screws before fully tighten- ing them.

Press the Shield Cover (37) into the Left and Right Shields (44, 45).

Avoid pinching the

Main Wire (42)

37

2

44, 45 79 78 78

79

1

5. Orient the Handlebar (39) as shown. Have a	5
second person hold the Handlebar near the
Upright (2).			79
		39
Locate the Sensor Wires (93) in the Handlebar
(39). Insert the right Sensor Wire into the right			79
side of the Upright and insert the left Sensor
Wire into the left side of the Upright. Pull the
Sensor Wires upward out of the top of the
Upright.	2	93

Tip: Avoid pinching the wires. Attach the

Handlebar (39) to the Upright (2) with three M10Avoid pinching the wires

x 20mm Screws (79).

8