6. The Console (4) can use four D batteries (not included); alkaline batteries are recom- mended. IMPORTANT: If the Console has been exposed to cold temperatures, allow it to warm to room temperature before insert- ing batteries. Otherwise, you may damage the console displays or other electronic components.
Remove the battery covers from the back of the Console (4), and insert batteries into the battery compartments. Make sure to orient the bat- teries as shown by the diagrams inside the battery compartments. Then, reattach the bat- tery covers.
To purchase an optional power adapter, call the telephone number on the cover of this manual. To avoid damaging the console, use only a
7.Untie and discard the wire tie on the Main Wire (42).
While a second person holds the Console (4) near the Upright (2), connect the wires on the Console to the Main Wire (42) and to the Sensor Wires (93).
Insert the excess wire into the Upright (2) or into the Console (4).
Tip: Avoid pinching the wires. Attach the Console (4) to the Upright (2) with four M4 x 16mm Screws (92).
8.Orient the Rear Console Cover (81) as shown.
Have a second person hold the Rear Console Cover (81) against the Upright (2) until you com- plete step 9.
6
Battery
Cover
4
Battery
Cover
7
4 | Avoid pinching |
| |
| the wires |
| 42 |
| 2 |
93
92
8
81
2
9