Precor C764 owner manual Diagram 4 Remove the handrail Clamp

C O M M E R C I A L P R O D U C T S D I V I S I O N

Diagram 4 Remove the handrail

clamp.

Handrail clamp

Nylock nuts inside upper column

Upper column

5.Remove the handrail clamp from the upper column. Diagram 4. Nylock® nuts inside the upper column secure the two handrail clamp screws. Hold the two screws with a 3/16-inch Allen wrench and use a 1/2-inch box end wrench to loosen the nuts. Carefully place your hand inside the upper column to catch the nuts as they become loose. Set the fasteners and clamp aside for use in a later step.

Diagram 5 Attach the lower portion of the handrails to the C764 and upper portion to the handrail clamp.

Handrail

Handrail boot (J)

Screw (F) with locknut (G)

Base mount

6.Have an assistant hold the upper portion of the handrails while you slide a handrail boot (J) onto the base of each handrail. Refer to the inset in Diagram 5. Be sure to mount the bell-shaped boot properly. The wide portion of the “bell” should be facing toward the base.

7.Place the end of the handrails onto the base mounts and align the mounting holes. Diagram 5. Insert two screws (F) through each handrail mount. Attach a locknut (G) to the opposite end of the screw and finger tighten. Do not wrench tighten the screws at this point.

page 13