Precor EC860 owner manual Getting Service

Page 23

7.Test the Hall 1 speed sensor by SLOWLY moving the pedals. Continue pedaling for about 1 minute. The asterisk to the right of “Hall 1” will blink on and off if the sensor is working correctly. If the asterisk stays solid, the cycle needs servicing. Please note that only Hall 1 is used; ignore Hall 2.

8.To exit the Diagnostic program, either use the power switch to turn the cycle OFF then ON, or press ENTER/RESET three times. In either case, the initial start-up prompt, “Choose Workout Program,” appears.

Getting Service

Do not attempt to service an EC860 cycle yourself except for the maintenance and diagnostic tasks described in this manual. The EC860 cycle does not contain any user-serviceable parts.

To contact a Precor Commercial Products Customer Service Representative, call 1-800-347-4404.

page 23

Page 22 Page 24
Image 23
Page 22 Page 24
Contents EC860 Safety Information Table of Contents About this Manual Before You BeginRecumbent Cycle Setting Up the EC860 ProfessionalInstallation Requirements Using the Club Setting Program Diagram Understanding the Electronic Console Using the EC860 ProfessionalKeypad Right Display Window Proper leg position Adjusting the SeatTurning the Cycle on and OFF Using Manual Mode Workout ProgramExercising on the EC860 Cycle Profiles Page User Programming screen Designing a Customized CoursePage Muscles exercised during an EC850 workout Getting the Most Out of Your Workout100% How Hard Should I Exercise?How Often Should I Exercise? How Long Should I Exercise?Maintaining the EC860 Professional Cleaning the CycleUsing the Diagnostic Program Diagram 7 Diagnostic screen Getting Service Readouts Appendix A. SpecificationsSpecifications ChassisUSA
Top Page Image Contents