Precor c954 owner manual M M E R C I a L O D U C T S V I S I O N

C O M M E R C I A L		P R O D U C T S	D I V I S I O N
Diagram 5	Remove the
	shipping
	fasteners from
	the left side front
	panel.
	Shipping
	fasteners found
	on left and right
	sides of the front
	panel.
	Left side
	mounting
	bracket

5.Attach the left side upright support. Diagram 5. Take the following steps.

a.Remove the shipping fasteners from the front panel. With the supplied hex key and a ½-inch box end wrench, loosen and remove the two bolts, washers and nuts on the left side of the front panel. These fasteners hold the front panel in place during shipping. (The front panel will drop slightly when you remove the fasteners.) Discard the nuts, but keep the bolts and washers.

Diagram 6	Secure the left	1	2
	upright support.
	Screws (D),
	washers (E),
	and barrel
	spacers (F)
	Left upright
	support

b.Attach the left upright support by placing it inside the base mount and aligning the mounting holes. Obtain two bolts, washers and barrel spacers from the Hardware kit. Place a washer and barrel sleeve on each bolt and insert the fasteners through the side of the upright support and into the base mounts. Use the 1/4-inch hex key to secure the bolts, but leave room for adjustments. See Diagram 6, #1.

c.Reinsert the two shipping fasteners (bolts and washers only) removed in step 5a, and finger tighten. See Diagram 6, #2.

page 12