Precor 9.21 manual Storing the Chest Strap, Checking the Alignment Running Belt

Page 33

Periodically, clean the running belt using a soft nylon scrub brush. Frequently vacuum the floor underneath the unit to prevent the accumulation of dust and dirt, which can affect the smooth operation of the unit.

Storing the Chest Strap

Store the chest strap where dust and dirt cannot accumulate on it, such as a closet or drawer. Be sure to keep the chest strap protected from extremes in temperature. Do not store it in an area that may be exposed to temperatures below 32° F (0° C).

To clean the chest strap, use a sponge or soft cloth dampened in mild soap and water. Dry the surface thoroughly with a clean towel.

Checking the Alignment of

the Running Belt

Proper belt alignment allows the belt to remain centered for smooth operation. Realigning the belt takes a few simple adjustments. If you are unsure about this procedure, call Precor Customer Support. Refer to Obtaining Service.

CAUTION: Special care must be taken when aligning the running belt. Turn OFF the treadmill while adjusting or working near the rear roller. Remove any loose clothing and tie back your hair. Be very careful to keep your fingers and any other object clear of the belt and rollers, especially in front of the roller and behind the deck. The treadmill will not stop immediately if an object becomes caught in the belt or rollers.

1.The treadmill has adjustable rear feet. Make sure that the running surface is level. If the treadmill is placed on an uneven surface, adjusting the rear feet can help, but will not compensate for extremely uneven surfaces.

2.Turn the unit ON.

Note: The treadmill will not operate unless the red magnet is appropriately placed on the display console.

3.Stand beside the treadmill and press QUICKSTART.

The running belt starts automatically after a 3-second countdown appears on the display.

4.Press the SPEED ▲ key until the display shows a speed of 3 mph (5 kph).

CAUTION: If you hear any chafing or the running belt appears to be getting damaged, stop the running belt immediately by pressing the STOP key. Contact Precor Customer Support.

Owner’s Manual: Maintenance

31

Image 33
Contents  Page Important Safety Instructions See Grounding Instructions Safety ApprovalUnits Designated for U.S. Markets Grounding InstructionsProduct Recycling and Disposal Obtaining ServiceTable of Contents Treadmill Safety Features Using the Safety ClipUsing the Handrails Turning the Unit on and OFF Using the Reset SwitchGuidelines Heart Rate FeaturesExercise to Your Target Heart Rate Keypad Use the keypad to Display ConsolePage Page Incline KeypadQuickstart Choosing Quickstart Workout OptionsENTER/SELECT Selecting a ProgramCooling Down After a Workout Ending a Workout Pausing During a Workout or the Cool-Down PeriodChoosing a Program ProgramsManual Manl Program Program TipsWeight Loss WLS Program Random Rand Program Interval Intv ProgramHeart Rate Control HRC Program Walk Walk ProgramWarm-up Period Advanced Programming and Troubleshooting Programming TipsSelecting a U.S. Standard or Metric Display Viewing the Odometer Informational Displays21.30 Troubleshooting Error Codes Red Reset ButtonWhat Appears on Display Cause What to Do Troubleshooting Heart Rate IssuesMaintenance Cleaning the EquipmentInspection Checking the Alignment Running Belt Storing the Chest StrapAdjusting the Running Belt Servicing the Treadmill Long-Term Storage Limited Warranty Precor Residential Equipment Limited WarrantyConditions and Restrictions Exclusive Remedies Page Page Thank You and Welcome to Precor Tell US about Your NEW Precor Product Page Low Impact Treadmill