5.Walk around to the rear of the unit and observe the belt for a few minutes. The belt should be centered on the platform. If the belt drifts off center, you must make adjustments.
Important: If the belt needs alignment, make the adjustments at once. Failure to align the belt may cause the belt to tear or fray, which is not covered by the Precor Limited Warranty.
6.To stop the running belt, press the STOP key.
7.Turn the treadmill OFF.
Adjusting the Running Belt
If you are unsure about adjusting the running belt, call Precor Customer Support (see Obtaining Service).
CAUTION: Always use the I/O power switch to turn OFF the treadmill before making any adjustments. Do not adjust the running belt when someone is standing on the unit.
1.Locate the right belt adjustment bolt in the rear end cap of the treadmill. Refer to Diagram 12.
Diagram 12: Adjusting belt location
To determine left and right, stand at the rear of the treadmill and face the display.) Make all belt adjustments on the right rear corner bolt using the hex key provided.
•If the belt is off center to the LEFT, turn the adjusting bolt ¼ turn counterclockwise, which moves the running belt to the right.
•If the belt tracks off center to the RIGHT, turn the bolt ¼ turn clockwise; this moves the belt to the left.
Important: Do not turn the adjusting bolt more than
¼ turn at a time. Overtightening the bolt can damage the treadmill.
2.Recheck the alignment of the running belt.
Owner’s Manual: Maintenance | 32 |