JVC RX-8000VBK Storing the Basic Settings Adjustments One Touch Operation, Using the Sleep Timer

Storing the Basic Settings and

Adjustments — One Touch Operation

JVC’s One Touch Operation function is used to assign and store different sound settings for each different playing source. By using this function, you do not have to change the settings every time you change the source. The stored settings for the newly selected source are automatically recalled.

The following can be stored for each source:

•Volume level (see page 11)

•Bass boost (see page 12)

•Input attenuator mode (see page 12)

•Subwoofer output level (see page 12)

•Balance (see page 13)

•SEA modes (see page 21)

•DSP modes

–3D-PHONIC mode settings (see page 25)

–DAP mode settings (see page 25)

–Surround mode settings (see page 26)

•DVD MULTI playback mode settings (see page 31)

On the front panel ONLY:

To store the sound settings

1. Press ONE TOUCH OPERATION. ONETOUCHOPERATION

The ONE TOUCH OPERATION lamp lights up, then the previously memorized settings are recalled.

2. Adjust the sound using the functions listed above.

The newly adjusted settings are memorized.

To recall the sound settings

With the ONE TOUCH OPERATION lamp lit, the settings for the currently selected source are recalled when the source is selected.

To cancel the One Touch Operation function

Press ONE TOUCH OPERATION so that the lamp goes off. (Even though the One Touch Operation function is canceled, the recalled sound effects remain active.)

Notes:

•If the source is FM or AM, you can assign a different setting for each band.

•The DSP modes and DVD MULTI playback mode cannot be used at the same time.

Using the Sleep Timer

Using the Sleep Timer, you can fall asleep to music and know the receiver will turn off by itself rather than play all night.

From the remote control ONLY:

Press SLEEP repeatedly. SLEEP

The SLEEP indicator lights up on the display, and the shut-off time changes as follows (in minutes):

10 20 30 40 50 60 70 80 90

00(Canceled)

When the shut-off time comes

The receiver turns off automatically.

To check or change the time remaining until the shut-off time

Press SLEEP once.

The remaining time until the shut-off time appears in minutes.

• To change the shut-off time, press SLEEP repeatedly.

To cancel the Sleep Timer

Press SLEEP repeatedly until “SLEEP 00min.” appears on the display. (The SLEEP indicator goes off.)

• Turning off the power also cancels the Sleep Timer.

18