JVC RX-8000VBK manual Using the DVD Multi Playback Mode, Activating the DVD Multi Playback Mode

Using the DVD MULTI Playback Mode

This receiver provides the DVD MULTI playback mode for reproducing the analog discrete output mode of the DVD player. Before playing back a DVD, refer also to the manual supplied with the DVD player.

IMPORTANT:

When using the remote control, check to see if its
remote control mode selector is set to the correct	AUDIO/
position:	TV/VCR
To operate this receiver, set it to “AUDIO/TV/
	CATV/DBS
VCR.”

Activating the DVD MULTI Playback Mode

You can adjust the DVD MULTI playback mode while playing back a DVD using the analog discrete output mode on the DVD player. Once you have made adjustments, the receiver memorizes the

4.Adjust the center tone.

1)Press BALANCE/SURROUND ADJUST repeatedly until “CENTER TONE” appears on the display.

The display changes to show the current setting.

2)Turn MULTI JOG to select the center tone level you want.

The center tone adjustment affects the mid-frequency range, which the human voice is mostly made up of.

•As you turn it, the display changes to show the following:

BALANCE/SURROUND

ADJUST

MULTI JOG

adjustments until you change them. You also need to set the DVD player to the analog discrete output mode.

Before you start, remember...

•There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 1 again.

CENTER SHARP1 CENTER SHARP2 CENTER FLAT

(Canceled)

CENTER SOFT 1 CENTER SOFT 2

To make the dialogue clearer, select “CENTER SHARP1”

(little) or “CENTER SHARP2” (much).

On the front panel:

1. Turn SOURCE SELECTOR until “DVD MULTI” appears on the display.

Note:

SOURCE SELECTOR

To make the dialogue softer, select “CENTER SOFT 1” (little) or “CENTER SOFT 2” (much).

When “CENTER FLAT” is selected, no adjustment is applied.

When you select “DVD MULTI” as the source to play, the DSP mode is canceled temporarily, and the SURROUND ON/OFF and DSP MODE buttons do not work.

2.Select the analog discrete output mode on the DVD player, and start playing a DVD.

• Refer to the manual supplied with the DVD player.

If you need to make any adjustment, go to the following steps.

3. Adjust the speaker output levels.	BALANCE/SURROUND
		ADJUST

1)Press BALANCE/SURROUND ADJUST repeatedly until one of the indications appears on the display. “CENTER LEVEL”:

To adjust the center speaker level. “REAR L LEVEL”:

To adjust the left rear speaker level. “REAR R LEVEL”:

To adjust the right rear speaker level.

2)Turn MULTI JOG to adjust the selected speaker output level (from –10 dB to +10 dB).

3)Repeat 1) and 2) to adjust the other speaker output levels.

MULTI JOG

31