JVC RX-8000VBK manual Repeatedly until Theater, Appears on the display, Center tone level you want

JVC Theater Surround adjustments

Before you start, remember...

•Make sure that you have set the speaker information correctly (see page 14).

•There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 1 again.

•You cannot adjust the rear speaker output levels when you have set “REAR SPK” to “NONE.” See page 14.

•You cannot adjust the center speaker output level and center tone when you have set “CENTER SPK” to “NONE.” See page 14.

From the remote control:

1. Press SURROUND MODE	SURROUND
	MODE
repeatedly until “THEATER”
appears on the display.

The Ù PRO LOGIC and DSP indicators also light up on the display.

SOUND

2. Press SOUND.

The 10 keys are activated for sound adjustments.

3. Press TEST to check the speaker					TEST
	output balance.				4
	“TEST TONE L” starts flashing on the
	display, and a test tone comes out of the
	speakers in the following order:
	TEST TONE L		TEST TONE C		TEST TONE R
	(Left front speaker)		(Center speaker)		(Right front speaker)
		TEST TONE LS		TEST TONE RS
		(Left rear speaker)		(Right rear speaker)

Notes:

•You can adjust the speaker output levels without outputting the test tone.

•No test tone comes out of the center speaker when “CENTER SPK” is set to “NONE” (see page 14).

•No test tone comes out of the rear speakers when “REAR SPK” is set to “NONE” (see page 14).

•If the TV is turned on and the proper video input is selected on the TV, the test tone screen will appear on the TV.

5. Press TEST again to stop the test tone. TEST

4

6. Press CNTR TONE to select the	CNTR TONE
	1
center tone level you want.

The center tone adjustment affects the mid- frequency range, which the human voice is mostly made up of.

•Each time you press the button, the display changes to show the following:

CENTER SHARP1 CENTER SHARP2 CENTER FLAT

(Canceled)

CENTER SOFT 1 CENTER SOFT 2

To make the dialogue clearer, select “CENTER SHARP1” (little) or “CENTER SHARP2” (much).

To make the dialogue softer, select “CENTER SOFT 1” (little) or “CENTER SOFT 2” (much).

When “CENTER FLAT” is selected, no adjustment is applied.

7. Press EFFECT to select an effect	EFFECT
level you want.	7/P

•Each time you press the button, the effect level changes as follows:

DSP EFFECT 1 DSP EFFECT 2 DSP EFFECT 3

DSP EFFECT 5 DSP EFFECT 4

As the number increases, JVC Theater Surround becomes stronger.

4.Adjust the speaker output levels.

•To adjust the center speaker level, press CENTER –/+ (from – 10 dB to +10 dB).

•To adjust the left rear speaker level, press REAR•L –/+ (from –10 dB to +10 dB).

•To adjust the right rear speaker level, press REAR•R –/+ (from –10 dB to +10 dB).

CENTER REAR•L REAR•R

2 3 5 6 8 9

MENU ENTER

28