JVC RX-8000VBK manual Press DVD Multi so that DVD, Multi appears on the display

From the remote control:

1. Press DVD MULTI so that “DVD	DVD MUILTI
MULTI” appears on the display.

Note:

When you select “DVD MULTI” as the source to play, the DSP mode is canceled temporarily, and the SURROUND ON/OFF and SURROUND MODE buttons do not work.

2.Select the analog discrete output mode on the DVD player, and start playing a DVD.

• Refer to the manual supplied with the DVD player.

If you need to make any adjustment, go to the following steps.

SOUND

3. Press SOUND.

The 10 keys are activated for adjusting the sound.

4.Adjust the speaker output levels.

•To adjust the center speaker level, press CENTER –/+ (from – 10 dB to +10 dB).

•To adjust the left rear speaker level, press REAR•L –/+ (from –10 dB to +10 dB).

•To adjust the right rear speaker level, press REAR•R –/+ (from –10 dB to +10 dB).

CENTER REAR•L REAR•R

2 3 5 6 8 9

MENU ENTER

5. Press CNTR TONE to select the	CNTR TONE
center tone level you want.	1

•Each time you press the button, the display changes to show the following:

CENTER SHARP1 CENTER SHARP2 CENTER FLAT

(Canceled)

CENTER SOFT 1 CENTER SOFT2

To make the dialogue clearer, select “CENTER SHARP1”

(little) or “CENTER SHARP2” (much).

To make the dialogue softer, select “CENTER SOFT 1” (little) or “CENTER SOFT 2” (much).

When “CENTER FLAT” is selected, no adjustment is applied.

––––––––––––––– MEMO ––––––––––

Use this column to write down your DVD MULTI playback mode adjustments for your future reference.

32