ProForm PFTL79510.0 warranty HOW to Fold and Move the Treadmill, HOW to Fold the Treadmill

Page 25

HOW TO FOLD AND MOVE THE TREADMILL

HOW TO FOLD THE TREADMILL

To avoid damaging the treadmill, adjust the incline to the lowest position before you fold the treadmill. Then, remove the key and unplug the power cord.

CAUTION: You must be able to safely lift 45 lbs. (20 kg) to raise, lower, or move the treadmill.

1.Hold the metal frame firmly in the location shown by the arrow below. CAUTION: Do not hold the frame by the plastic foot rails. Bend your legs and keep your back straight.

1

Frame

2.Raise the frame until the latch knob locks in the storage position. CAUTION: Make sure that the latch knob locks.

2 Frame

Latch

Knob

To protect the floor or carpet, place a mat under the treadmill. Keep the treadmill out of direct sunlight. Do not leave the treadmill in the storage position in temperatures above 85° F (30° C).

HOW TO MOVE THE TREADMILL

Before moving the treadmill, fold it as described at the left. CAUTION: Make sure that the latch knob is locked in the storage position. Moving the tread- mill may require two people.

1.Hold the frame and one of the handrails, and place one foot against a wheel.

1

Frame

Handrail

Wheel

2.Pull back on the handrail until the treadmill will roll on the wheels, and carefully move it to the desired location. CAUTION: Do not move the treadmill without tipping it back, do not pull on the frame, and do not move the treadmill over an uneven surface.

3.Place one foot against a wheel, and carefully lower the treadmill.

HOW TO LOWER THE TREADMILL FOR USE

1.See drawing 2. Hold the upper end of the treadmill frame with your right hand. Pull the latch knob to the left; if necessary, push the frame forward slightly. Pivot the frame downward a few inches, and release the latch knob.

2.See drawing 1 at the left. Hold the metal frame firmly with both hands, and lower it to the floor.

CAUTION: Do not hold the frame by the plastic foot rails, and do not drop the frame. Bend your legs and keep your back straight.

25

Image 25
Contents Model No. PFTL79510.0 Serial No QUESTIONS?Mon.-Fri a.m.-6 p.m. MT Sat a.m.-4 p.m. MT On the WEBTable of Contents Important Precautions Instructions Save TheseBefore YOU Begin Wrench Scissors AssemblySee the inset drawing. Tie the wire tie Make sure that the power cord is unpluggedTighten the Bolts yet Attach the Right Upright not shown Be careful not to pinch the UprightBase Covers into place yet Attach the Right Handrail 87 in the same way Shown. Start all four Screws, and then tighten Each of them Important To avoid damagingAgain. if YOU do not Connect the CON Them All four Bolts, and then tighten eachPage Raise the Frame 56 to the position shown Page HOW to Plug in the Power Cord Operation and AdjustmentPRE-LUBRICATED Walking Belt Console Diagram Features of the Console HOW to USE the Manual Mode HOW to Turn on the PowerPage Turn on the fan if desired Measure your heart rate if desired. Before usingSelect an onboard workout HOW to USE AN Onboard WorkoutStart the workout Select a user HOW to USE AN Ifit Live WorkoutSelect an iFit Live workout Start the workout. See onInsert the Nike+ module into the console HOW to USE a NIKE+ ModuleConnect your iPod Record your workout informationInformation Mode Make sure that the audio wire is fully plugged HOW to USE the Stereo Sound SystemHOW to Fold the Treadmill HOW to Fold and Move the TreadmillHOW to Move the Treadmill HOW to Lower the Treadmill for USEProblem The power turns off during use TroubleshootingCompatible with GFCI-equipped outlets Top Problem The walking belt slows when walked onProblem Solution Exercise Intensity Exercise GuidelinesWorkout Guidelines Exercise FrequencyR1010A Part LIST-Model No. PFTL79510.0Qty Exploded Drawing A-Model No. PFTL79510.0 R1010A Exploded Drawing B-Model No. PFTL79510.0 R1010A Exploded Drawing C-Model No. PFTL79510.0 R1010A Exploded Drawing D-Model No. PFTL79510.0 R1010A Limited Warranty Ordering Replacement PartsIcon Health & Fitness, Inc., 1500 S W., Logan, UT