Not Connected PROPERLY, the CON | ProForm 831.24633.0 specs

5. Set the Console (43) face-down on a soft sur-

face to avoid scratching the Console. Next, set

one of the Handrails (71) on the Console as

shown. Attach the Handrail with three 3/4”

Screws (2). Make sure that the console wire is

not pinched. Start all three Screws before

tightening any of them. Do not overtighten

the Screws.

Attach the other Handrail (not shown) to the

other side of the Console (43) as described

above.

With the help of a second person, raise the

Uprights (not shown) to the vertical position.

6. Remove the plastic tie securing the Wire

Harness (42) to the right Upright (69). Next, in-

sert the colored tie on the Wire Harness up

through the large holes in the right Handrail (71)

as shown. Then, pull the Wire Harness up

through the holes.

Set the Handrails (71) and the Console (43) on

the Uprights (69). Make sure that the Wire

5
2
71
2
2
Console Wire
43
6
43

Harness (42) and the console wire are not

pinched. Discard the colored wire.

Next, connect the Wire Harness (42) to the con-

sole wire. Make sure to connect the connec-

tors properly (see the inset drawing). The

connectors should slide together easily and

snap into place. If they do not, turn one connec-

tor and try again. IF THE CONNECTORS ARE

NOT CONNECTED PROPERLY, THE CON-

SOLE MAY BE DAMAGED WHEN THE

POWER IS TURNED ON. Then, insert the con-

nectors and excess wire into the Console (43).

Colored Tie

	Console
42	Wire
42

Console

Wire

7.Tighten the four Handrail Bolts (37) with the four 1/4” Star Washers (95) into the Uprights (69) and the Handrails (71). Start all four Handrail Bolts before tightening any of them.

7
71
		37
37	95	95
37	95
		71	37
		71	95
			95
		69
			69
		37	95
8