ProForm PCTL79612.0 user manual Assembly, Make sure that the power cord is unplugged

Page 7

ASSEMBLY

Assembly requires two persons.

Place all parts in a cleared area and remove the packing materials. Do not dispose of the packing materials until you finish assembly.

After shipping, there may be an oily substance on the exterior of the treadmill. This is normal. If there is an oily substance on the treadmill, wipe it off with a soft cloth and a mild, non-abrasive cleaner.

Left parts are marked “L” or “Left” and right parts are marked “R” or “Right.”

To identify small parts, see page 6.

Assembly requires the following tools:

the included hex keys one adjustable wrench one Phillips screwdriver

scissors

needlenose pliers

To avoid damaging parts, do not use power tools.

1. Make sure that the power cord is unplugged.

1

 

Place a piece of cardboard below the rear of the

 

 

 

Frame (56) to protect the floor or carpet.

 

 

Attach the Left Wheel Cap (96) to the Base (94)

 

 

with two #8 x 3/4" Screws (2).

 

56

 

 

Attach the Right Wheel Cap (not shown) to

 

 

the right side of the Base (94) in the same

 

 

way.

94

 

 

 

 

2

 

 

 

96

 

 

Cardboard

2. Pull the Upright Wire (81) and the base ground

2

 

wire (A) through the indicated hole in the Base

 

 

 

(94).

 

 

Attach the base ground wire (A) to the Base (94)

 

77

with a #8 x 1/2" Ground Screw (10).

Hole

 

 

Press the Grommet (77) into the square hole in

81

 

the Base (94).

 

 

 

10

A

 

94

 

7

 

Image 7
Contents Model No. PCTL79612.0 Serial No QUESTIONS?Table of Contents Important Precautions Page Before YOU Begin Part Identification Chart Make sure that the power cord is unplugged AssemblyBe careful not to pinch the Upright Wire See the inset drawing. Tie the wire tieTighten the Screws yet Attach the Right Upright not shown Base Covers into place yet Shown. Start all four Screws, and then tighten Them 113 Console Assembly Make sure to follow All instructions This step Raise the Frame 56 to the position shown HOW to Connect the Power Cord Operation and AdjustmentUse a Surge Suppressor Features of the Console DiagramConsole Insert the key into the console HOW to Turn on the PowerHOW to USE the Manual Mode Select the manual modeCalories/Incline Change the incline of the treadmill as desiredTime display Turn on the fan if desired Measure your heart rate if desiredSelect an onboard workout HOW to USE AN Onboard WorkoutStart the workout Start the workout. See on HOW to USE AN Ifit Live WorkoutInsert the iFit Live module into the console Select an iFit Live workoutHOW to USE a Proform Sync Select the optional screens Information ModeSelect the information mode Exit the information modeMake sure that the iPod is fully plugged HOW to USE the Stereo Sound SystemHOW to Lower the Treadmill for USE HOW to Fold and Move the TreadmillHOW to Fold the Treadmill HOW to Move the TreadmillSymptom The power turns off during use TroubleshootingTop View Symptom The walking belt slows when walked onPage Exercise Frequency Exercise GuidelinesExercise Intensity Workout GuidelinesQty Description Part ListDescription Qty Exploded Drawing a Exploded Drawing B Exploded Drawing C Exploded Drawing D Limited Warranty Ordering Replacement Parts