ProForm PCTL79612.0 user manual See the inset drawing. Tie the wire tie

3. Identify the Left Upright (89). Have a second	3
person hold the Left Upright near the Base (94).
See the inset drawing. Tie the wire tie in the			81
				89
Left Upright (89) securely around the end of the
Upright Wire (81). Then, pull the other end of the				Wire
wire tie until the Upright Wire is routed through					81
the Left Upright.				Tie
			Wire
			Tie
	89
			81	94
4. Hold the Left Upright (89) against the Base (94).	4
Be careful not to pinch the Upright Wire (81).
Insert two 3/8" x 1 1/4" Screws (8) with two 3/8"
Star Washers (13) and two 3/8" x 2 3/4" Screws				81
(7) into the Left Upright.
		89
Partially tighten the 3/8" x 2 3/4" Screws (7) and
the 3/8" x 1 1/4" Screws (8) until the heads of the
Screws touch the Left Upright (89); do not fully
tighten the Screws yet.
Attach the Right Upright (not shown) in the		7
same way. Note: There are no wires on the right
side.
	13
	8	13	94
	8