10.Attach the ground wire on the Console Base (67) to the right Handrail (40) with a Silver Ground Screw (10).
Connect the wire harness on the Console Base (67) to the Upright Wire (69) as shown in the inset drawing. Important: If the connectors are oriented correctly, they will slide together easily and snap into place. If the connectors are not oriented correctly, the console may be damaged when the power is turned on.
Insert the connectors and excess wire into the Console Base (67).
11.Attach the Console Base (67) to the Handrails
(40)with four 3/4” Screws (3); do not tighten the Screws yet. Next, tighten two Console Bolts
(2)with 1/4” Star Washers (8) into the Handrails and the Console Base. Then, tighten the four
Screws.
12. Lower the Uprights (38, 39) as shown.
See the inset drawing. Push the Uprights (38,
39)sideways so that the treadmill Frame (36) is centered between the Uprights.
Firmly tighten the Upright Bolts (4) and the Frame Bolt (1) on each side of the treadmill. Do not overtighten the Frame Bolts.
10 | 67 |
| |
10 | Ground |
Wire | Wire |
Harness |
|
69 |
|
| 40 |
| 69 |
11 | 67 | Front View |
|
|
| ||
|
|
| |
40 |
|
| 40 |
|
|
| |
| 8 |
| 3 |
3 |
|
| |
2 |
| 8 | |
|
|
| |
|
|
| 2 |
12 |
| Side View | 1 |
|
| ||
|
| 38, 39 | 4 |
|
|
| |
|
| 36 |
|
View from Above
38 | 36 | 39 |
11