ProForm 7 manual Again. if the Connectors are not CON, Nected PROPERLY, the Console MAY

10. Remove the plastic ties from the Right Handrail	10
(90) and the Left Handrail (not shown). If neces-				Console Assembly
sary, press the Cage Nuts (38) into place.
Have a second person hold the console assem-
bly near the Right Upright (78). Remove the long
tie from the Upright Wire (77) and the tie from the
console wire.
Connect the Upright Wire (77) to the console
wire. See the inset drawing. The connectors
should slide together easily and snap into
place. If they do not, turn one connector and try		38
again. IF THE CONNECTORS ARE NOT CON-				90
NECTED PROPERLY, THE CONSOLE MAY	Plastic				Console
BE DAMAGED WHEN THE POWER IS		Ties		Console
TURNED ON. Then, insert the connectors into		77		Wire	Wire
the Right Upright (78).
Set the console assembly on the Right Upright
(78) and the Left Upright (not shown). Make sure			Long		77
that no wires are pinched.		78
				Tie
11. Partially tighten two M8 x 25mm Bolts (6) with	11
two M8 Star Washers (10) into the Left Upright
(73) and the Left Handrail (89).					110
Next, partially tighten two M8 x 25mm Bolts (6)						111
with two M8 Star Washers (10) into the Right
Upright (78) and the Right Handrail (90). Then,		Console
tighten all four Bolts.
See steps 4 and 6. Tighten the M10 x 96mm		Assembly
Bolts (5).	89
Press the Left Accessory Tray (110) and the
Right Accessory Tray (111) into the console as-			10	6
sembly.	6	10
				73	90
							10	6
					6	10	78
	11