6.With the help of a second person, hold a Bolt Spacer (79) inside the lower end of the Left Upright (73). Insert an M10 x 96mm Bolt (5) with an M10 Star Washer (8) into the Left Upright and the Bolt Spacer. Repeat this step with a second Bolt Spacer (79), M10 x 96mm Bolt (5), and M10 Star Washer (8).
Orient the Left Upright (73) and the Left Upright Spacer (83) as shown. Hold the Left Upright Spacer and the Left Upright against the Base (85). Partially tighten the M10 x 96mm Bolts (5); do not fully tighten the Bolts yet.
Press a Base Endcap (82) into the Base (85). With the help of a second person, tip the tread- mill so that the Base (85) is flat on the floor.
7.Set the console assembly face down on a soft surface to avoid scratching the console assem- bly. Remove the six M4.2 x 19mm Screws (1).
Save all six Screws for step 9. Lift off the Pulse Support (109).
6 | 5 |
| 73 |
|
| ||
| 8 | 83 |
|
|
|
| |
82 | 79 85 |
|
|
7 |
|
| 1 |
| Console Assembly | ||
|
| ||
|
| 1 |
|
1 | 109 |
|
|
9