ProForm PFB48031 user manual Tool. Make sure that the teeth on the Retainer

28. Attach the Butterfly Frame (42) to the Rear Top	28
Frame (39) with two M10 x 78mm Bolts (110), two		110
M10 Washers (99), and two M10 Nylon Locknuts		99
(97). Do not tighten the Locknuts yet.
		99
Attach the Butterfly Frame (42) to the Center		39
Upright (37) with two M10 x 68mm Bolts (113),
two M10 Washers (99), and two M10 Nylon		37
Locknuts (97). Do not tighten the Locknuts yet.
		97
Tighten all of the M10 Nylon Locknuts (97)	97
used in steps 11–28. Tighten the 1/4” x 14mm
Screws (119) used in step 22 and the 1/4” x
9.5mm Allen Head Set Screws (120) used in
step 23.		42
	99
	113
29. Lubricate both axles on the Butterfly Frame (42)	29
with grease.
Insert a Fly Arm Bushing (92) into the Right Fly	Lubricate Axle
Arm (43). Wet the end of the Arm and the inside	92
of a Fly Foam Pad (95) with soapy water and
		42
slide the Foam Pad onto the Arm.
	43	Bracket
Have another person slide the Right Fly Arm (43)
onto the right axle on the Butterfly Frame (42).	93	44
Note: Be careful not to confuse the Left Fly
Arm (44) with the Right Fly Arm. Make sure	94
that the upper end of the Arm is behind the
indicated bracket on the Butterfly Frame.
Tap two 25mm Retainer Rings (93) onto the axle of
the Butterfly Frame (42) with the included retainer	95
tool. Make sure that the teeth on the Retainer		Axle
Rings bend toward the tool, as shown in the
		42
inset drawing. Tap the 25mm Round Outer Cap
(94) onto the right axle on the Butterfly Frame.		93
Attach the Left Fly Arm (44) in the same
manner.		Retainer
		Tool
30. During cable assembly, refer to the CABLE	30
DIAGRAMS on page 22 for cable identification
and to verify cable routing.
Locate the Butterfly Cable (83). Attach the		129
Cable to the Left Fly Arm (44) with an M8 x
16mm Shoulder Bolt (129) and an M8 Nylon		83
Locknut (96).
		96
	44
	14