ADJUSTMENTS
This section explains how to adjust the weight bench. See the EXERCISE GUIDELINES on page 24 for impor- tant information about how to get the most benefit from your exercise program. Refer to the accompanying exer- cise guide to see the correct form for each exercise.
Make sure all parts are properly tightened each time the weight bench is used. Replace any worn parts immediate- ly. The weight bench can be cleaned with a damp cloth and a mild,
ADJUSTING THE BACKREST
To adjust the position of the Backrest (14), hold the upper end of the Backrest with one hand and lift the Adjustment Lever (11) with the other hand, disengag- ing the Backrest Bracket (7). Raise or lower the Backrest to the desired position. Lower the Adjust- ment Lever so that the M10 x 62mm Flat Head Screw (27 [not shown]) engages one of the notches in the Backrest Bracket.
WARNING: Always hold the Backrest (14) securely before disengaging the Backrest Bracket (7). Always make sure the Backrest Bracket is fully engaged before using the Backrest.
ATTACHING THE CURL POST
For some exercises, the Curl Post (6) must be attached to the weight bench. Slide the Curl Post into the Leg Lever Bracket (5). Align the adjustment holes in the Curl Post with the adjustment hole in the Leg Lever Bracket. Tighten the Curl Knob (29) into the adjustment hole in the Leg Lever Bracket. Fully tight- en the Knob.
When not being used, the Curl Post (6) can be stored on the tube on the Right Base (34) (see the inset drawing).
| 14 |
| 27 |
| 11 |
7 |
|
6 | 29 |
| |
5 |
|
| 6 |
| 34 |
19