ProForm PFB48031 user manual Locknut the Cable must be able to pivot easily

Page 18

44. Attach the Low Cable (82) inside the Rear Base	44
(33) with an M10 x 75mm Bolt (127), two M10	44
(33) with an M10 x 75mm Bolt (127), two M10
Washers (99), two 27mm Spacers (87), and an
M10 Nylon Locknut (97). Do not overtighten the	97	99
Locknut; the Cable must be able to pivot easily.	97	99
		87		33
				82
			87	127
				99
45. Attach the Butterfly Backrest (80) to the Center	45
Upright (37) with two M6 x 72mm Screws (105)	45
Upright (37) with two M6 x 72mm Screws (105)
and two M6 Washers (101).
		80	37	105
		80		105
				101
				101
				105

46.Make sure that all parts have been properly tightened. The use of the remaining parts will be explained in ADJUSTMENTS, beginning on the following page.

Before using the weight bench, pull each cable a few times to make sure that the cables move smoothly over the pulleys. If one of the cables does not move smoothly, find and correct the problem. IMPORTANT: If the cables are not properly installed, they may be damaged when heavy weight is used. See the CABLE DIAGRAMS on page 22 of this manual for proper cable routing. If there is any slack in the cables, you will need to remove it by tightening the cables. See TROUBLESHOOTING on page 23.

18

Image 18

Contents QUESTIONS? Model No. PFB48031 Serial NoCustomer HOT Line Table of Contents Important Precautions Before YOU Begin Right SideLeft Side Stabilizer in the same manner AssemblyMake Things Easier for Yourself Locknuts yetLubricate Flat Head Screw 27 is under a notch in the Backrest Bracket Tighten the six M10 Nylon Locknuts 97 used in steps 1104 Numbers 113 108 Do not tighten the Locknuts yet As shown Locknuts 97. Do not tighten the Locknuts yet Not tighten the Screw yetNylon Locknut 97. Do not tighten the Locknut Yet 130 Tool. Make sure that the teeth on the Retainer Rings bend toward the tool, as shownAttach the Left Fly Arm 44 in the same Manner Page Locate the Lat Cable 81. Route the Cable up Cable Trap is turned to hold the Cable Groove of the PulleyLocknut the Cable must be able to pivot 127 Locknut the Cable must be able to pivot easily Adjustments Adjusting the BackrestAttaching the Curl Post Using the Olympic Weight Adapter Adding Weights to the LEG LeverAttaching the Accessories Adding Weights to the Barbell or the Weight Carriage Using the Locking BARMoving the Safety Spotters Lat Cable Cable DiagramsButterfly Cable Low CableTroubleshooting Tightening the CablesExercise Guidelines Muscle Chart Cooling DownStaying Motivated Aerobic Exercise Exercise Weight Sets RepsDate Thursday Aerobic Exercise DateMonday Part Identification CHART-Model No. PFB48031 R1204APage Part LIST-Model No. PFB48031 Key Qty DescriptionExploded DRAWING-Model No. PFB48031 101 Ordering Replacement Parts Limited WarrantyIcon Health & FITNESS, INC., 1500 S W., LOGAN, UT