ASSEMBLY
Place all parts of the PROFORM¨ L.E.X. in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed.
In addition to the included allen wrench and flat wrench, a phillips screwdriver 
and two
adjustable wrenches 
are required for assembly.
1.Position the Stabilizer (4) against the saddle on the Frame (1). Insert two M10 x 75mm Button Head Bolts (45) through the Frame and the Stabilizer. Tighten M10 Nylon Locknuts (46) onto the Button Head Bolts.
2.Attach a Pedal (9) to the Left Pedal Arm (7) with three M4 x 16mm Screws (51).
If there is not a Wheel (60) on the Left Pedal Arm (7), attach a Wheel in the following way: Place a Wheel inside of a Wheel Cover (59). Hold the Wheel and the Wheel Cover inside of the bracket on the Left Pedal Arm (7). Insert an M8 x 55mm Hex Head Bolt (63) through the bracket, Wheel Cover, and Wheel. Tighten an M8 Nylon Locknut (64) on the Hex Head Bolt.
Assemble the Right Pedal Arm (not shown) in the same way.
3.Insert a Pedal Bolt (36) through the bushings in the Left Pedal Arm (7). Using the included flat wrench, tighten the Pedal Bolt into the left arm of the Crank (38). Next, back the Pedal Bolt out of the Crank half of a turn. While holding the Pedal Bolt station- ary, tighten a 1/2Ó Nylon Locknut (37) onto it.
Attach the Right Pedal Arm (not shown) in the same way.
1 |
|
|
| 45 |
|
|
| 1 |
|
| 4 |
45 |
|
|
|
| 46 |
| 46 |
|
2 |
|
|
|
| 9 |
| 7 |
|
| 51 | 59 |
|
| |
| Bracket | 64 |
|
| |
| 63 | 60 |
3 | 37 |
|
|
| |
Bushings |
| |
| 38 |
|
36 | 7 |
|
|
| |
6