![](/images/new-backgrounds/1320261/32026113x1.webp)
5.The Console (16) requires four “D” batteries (not included); alkaline batteries are recommended. Press the tab on the battery door and remove the battery door. Insert four batteries into the Console as shown.
Make sure that the batteries are oriented as shown by the markings on the battery door. Then, reattach the battery door.
6.Hold the Console (16) near the Upright (13). Connect the console wire to the Upper Wire Harness (36).
Insert the excess console wire and Upper Wire Harness (36) down into the Upright (13). Next, attach the Console (16) to the Upright with four M4 x 16mm Screws (49). Be careful to avoid pinching the wires.
7.Attach the Seat Frame (28) to the Frame (1) with three M8 x 25mm Button Screws (45) and three M8 Split Washers (41).
5 |
|
| 16 |
| Batteries |
Batteries |
|
| Door |
6 |
|
Console |
|
Wire |
|
49 | 16 |
| 36 |
| Be careful to |
49 | avoid pinching |
the wires. | |
| 13 |
7 |
|
41 | 45 |
| |
45 |
|
41 |
|
45 | 28 |
| |
1 |
|
7