JVC RX-7020VBK manual Press Test to check if you can hear, Equal level, Press Control UP

SURROUND MODE

3 Press SOUND. SOUND

The 10 keys are activated for sound adjustments.

4 Press TEST to check if you can hear								TEST
	the sounds through all the speakers at							4
	the equal level.
	“TEST TONE L” starts flashing on the
	display, and a test tone comes out of the
	speakers in the following order:
		TEST TONE L		TEST TONE C			TEST TONE R
		(Left front speaker)		(Center speaker)			(Right front speaker)
			TEST TONE LS			TEST TONE RS
			(Left rear speaker)		(Right rear speaker)

Notes:

•You can adjust the speaker output levels without outputting the test tone.

•No test tone comes out of the center speaker when “CNTR SP” is set to “NONE.”

•No test tone comes out of the rear speakers when “REAR SP” is set to “NONE.”

5Adjust the speaker output levels (–10 to +10).

Adjust the center speaker and rear speakers levels comparing to the sound from the front speakers.

On the front panel:

You can also use the buttons on the front panel to adjust the Surround modes. However, no test tone is available when using the buttons on the front panel. So make adjustments while listening to the sound of the source played back.

1Setting the analog or digital input mode for the

source you like to hear and start playing.

When playing back software encoded with Dolby Digital and DTS Digital Surround, select the digital input mode (see page 15).

2 Press SURROUND ON/OFF to	SURROUND ON/OFF
activate Surround mode.

Each time you press the button, Surround mode turns on and off alternately.

•If you are playing back software encoded with Dolby Digital multichannel, “DOLBY DIGITAL” is selected.

•If you are playing back software encoded with DTS Digital Surround, “DTS SURROUND” is selected.

• If you are playing back any software other than above, you can select “PL II MUSIC” or “PL II MOVIE” according to the source by pressing SURROUND MODE. ( PRO LOGIC II indicator lights up on the display.)

If you like to adjust sound, go to step 3.

Creating Realistic Sound Fields

•To adjust the center speaker level, press CENTER +/–.

•To adjust the left rear speaker level, press REAR•L +/–.

•To adjust the right rear speaker level, press REAR•R +/–.

6Press TEST again to stop the test tone.

–CENTER+

2 3

MENU

–REAR• L+

5 6

ENTER

ENTER

–REAR• R+

8 9

TEST

4

3Adjust the speaker output levels.

1)	Press ADJUST repeatedly until one	ADJUST SETTING
	of the following indications (with the
	current setting)* appears on the
	display.

	SPK 1			TUNED STEREO	AUTOMUTING
DIGITAL AUTO	L	C	R	PROLOGIC ΙΙ DSP H.PHONE INPUT ATT	VOLUME
LINEAR PCM	S.WFR LFE
	LS	S	RS

*“0” is the initial setting. If you have already changed the setting, another number (level) will be shown.

CENTER : To adjust the center speaker output level (–10 to +10).

REAR L : To adjust the left rear speaker output level (–10 to +10).

REAR R : To adjust the right rear speaker output level (–10 to +10).

2) Press CONTROL UP 5/	DOWN UP
	CONTROL
DOWN ∞ to adjust the selected
speaker output levels.

3)Repeat steps 1) and 2) to adjust the other speaker levels.

27