JVC RX-7020VBK manual Connecting Audio/Video Components, Connecting the rear and center speakers

Page 8

Getting Started

Connecting the rear and center speakers

Connect rear speakers to the REAR SPEAKERS terminals and a center speaker to the CENTER SPEAKER terminals.

 

Center

 

 

 

speaker

 

 

 

 

 

CENTER

REAR

 

 

 

SPEAKER

SPEAKERS

Left rear

Right rear

+

 

 

 

 

 

speaker

speaker

 

 

 

 

 

–

 

 

 

 

 

RIGHT

LEFT

1

2

3

4

 

 

1

1

 

1

 

RIGHT

RIGHT

 

RIGHT

Connecting Audio/Video Components

Turn the power off to all components before connections.

You can connect the following audio/video components to this unit. Refer also to the manuals supplied with your components.

Audio Components

Video Components

 

 

• Turntable

• VCR

 

 

• CD player*

• TV*

• Cassette deck

or DBS tuner*

 

 

or CD recorder*

• DVD player*

*You can connect these components using the methods described in “Analog connections” (below) or in “Digital connections” (see page 9).

Analog connections

Audio component connections

Use the cables with RCA pin plugs (not supplied).

Connect the white plug to the audio left jack, and the red plug to the audio right jack.

CAUTION:

If you connect a sound-enhancing device such as a graphic equalizer between the source components and this receiver, the sound output through this receiver may be distorted.

For each speaker , connect the (+) and (–) terminals on the rear panel to the (+) and (–) terminals marked on the speakers.

1Cut, twist and remove the insulation at the end of each speaker signal cable (not supplied).

2Turn the knob counterclockwise.

3Insert the speaker signal cable.

4Turn the knob clockwise.

Turntable

If an earth cable is provided for your turntable, connect the cable to the AM LOOP(H) terminal on the rear panel.

Turntable

Connecting the subwoofer speaker

By connecting a subwoofer, you can enhance the bass or reproduce the original LFE signals recorded in the digital software.

AUDIO

RIGHT

LEFT

FRONT

 

Powered subwoofer

DVD

 

SUB

CENTER

WOOFER

 

REAR

 

RIGHT

LEFT

To audio output

Ex.: This connection is for the turntable with an MM (moving- magnet) type cartridge.

PHONO

CD

OUT

(REC)

TAPE

CDR

IN

(PLAY)

OUT

(REC)

VCR

IN

(PLAY)

TV

SOUND

DBS

RIGHT LEFT

SUBWOOFER

OUT

Connect the input jack of a powered subwoofer to the SUBWOOFER OUT jack on the rear panel, using a cable with RCA pin plugs (not supplied).

•Refer also to the manual supplied for your subwoofer.

Since bass sound is non-directional, you can place a subwoofer wherever you like. Normally place it in front of you.

Note:AUDIO

Any turntables incorporating a small-output cartridge such as an MC (moving-coil) type must be connected to this receiver through a commercial head amplifier or step-up transformer. Direct connection may result in insufficient volume.

6

Page 7 Page 9
Image 8
Page 7 Page 9
Contents RX-7020VBK Mises en garde, précautions et indications diverses For Canada/pour le CanadaTable of Contents Remote Control Parts IdentificationFront Panel See pages in the parentheses for detailsBefore Installation Putting Batteries in the Remote Control Checking the Supplied AccessoriesGetting Started Replace the coverConnecting the FM and AM Antennas Getting StartedAM antenna connection FM antenna connectionConnecting the Speakers Speaker layout diagramConnecting the front speakers Connection diagramConnecting Audio/Video Components Connecting the rear and center speakersConnecting the subwoofer speaker Analog connections Audio component connectionsVideo component connections CD playerCassette deck or CD recorder VCRWhen you connect the DVD player with stereo output jacks TV and/or DBS tuner DVD playerDVD player DBS tuner BConnecting the Power Cord Plug the power cord into an AC outletDigital connections Digital output terminalTurning On the Power To turn off the power into standby modeBasic Operations Selecting the Source to PlayAdjusting the Volume Listening Only with Headphones Turning Off the Power With the Sleep TimerBasic Operations Changing the Display BrightnessBasic adjustment auto memory Signal and speaker indicators on the displaySignal indicators Speaker indicators Speaker indicators light up whenDigital in Terminals Basic SettingsSetting the Digital Input Selecting the Analog or Digital Input Mode Basic Settings Setting the Speaker Information RemoteUnit with the current setting Appears on the display Press Control UP 5/DOWN ∞ to select the unitSelect the appropriate speaker distance Speaker sizePress Setting repeatedly until LFE T Setting Select the low frequency effect attenuator levelTo select the appropriate compression LevelOutput Balance Sound AdjustmentsAdjusting the Front Speakers Sound Adjustments Adjusting the ToneAdjusting the Subwoofer Output Level Reinforcing the BassTuning in Stations Manually Using Preset TuningPress FM/AM Preset 5/∞ to Tuner OperationsSelecting the FM Reception Mode Tuner OperationsCreating Realistic Sound Fields Dolby SurroundDTS Digital Surround Typical Multichannel 5.1 ch reproductionCreating Realistic Sound Fields About Relations between Speaker Layouts and Surround Modes Turning on or off the Surround modesSelecting the Surround modes Available Surround modesActivate Surround mode If you like to adjust sound, go to stepSource you like to listen and start playing Press Surround ON/OFF toAdjust the speaker output levels -10 to +10 Press Test to check if you can hearEqual level Press Test again to stop the test toneUsing DAP Modes and All Channel Stereo Press Surround ON/OFF to activate Surround mode Press Surround Mode repeatedly Surround ModeOnly for DAP modes Adjust the effect level PAVILION-or ALL CH Stereo appears on the displayUsing DVD Multi Playback Mode Activating DVD Multi Playback ModePress DVD Multi Following indications appears On the displayCompu Link Remote Control System Press the play 3 button on the CD playerAutomatic Source Selection Synchronized RecordingAV Compu Link Remote Control System Connections 1 AV Compu Link ConnectionConnections 2 Video Cable Connections CaseAutomatic Selection of TV’s Input Mode Automatic Power On/OffOne-Touch Video Play One-Touch DVD PlaySound Adjustment Ex. When you press CDOperating JVC’s Audio/Video Components Operating Audio ComponentsCD player CD changerTurntable Cassette deckOperating JVC’s Audio/Video Components Operating Video ComponentsDVD player You can always perform the following operationsTo change the transmittable signals for operating a TV Operating Other Manufacturers’ Video EquipmentTry to operate your TV by pressing TV OperatingTry to operate your VCR by pressing To change the transmittable signals for operating a VCROperating Other Manufacturers’ Video Equipment Manufacturers’ codes for DVD player Codes Try to operate your DVD player by pressingManufacturers’ codes for VCR Codes Troubleshooting Problem Possible Cause SolutionSpecifications Per channel, min. RMS, driven into 8 ΩHz to 20 kHz with no more than 0.8% total Harmonic distortionSpecifications FM tuner IHFAM tuner GeneralAuthorized Service Centers Limited Warranty 1201NHMMDWJEIN

RX-7020VBK specifications

The JVC RX-7020VBK is a versatile and powerful audio receiver designed to provide an immersive sound experience for home theater enthusiasts and casual listeners alike. This 5.1-channel receiver supports various audio formats and delivers high-quality sound that complements any entertainment setup. One of the standout features of the RX-7020VBK is its impressive power output. With 100 watts per channel, this receiver ensures that your audio fills the room with rich and dynamic sound. It is perfect for movies, music, and gaming, allowing every detail to come to life.

In terms of connectivity, the JVC RX-7020VBK offers multiple input options, including HDMI, digital optical, coaxial, and analog inputs. This wide range of connectivity options allows users to connect various devices such as Blu-ray players, gaming consoles, and streaming devices, making it a versatile choice for any home entertainment system. The receiver also includes AM/FM radio capabilities, giving users access to a variety of listening options.

The RX-7020VBK is equipped with Dolby Digital and DTS surround sound technologies, providing a surround sound experience that enhances movie watching and gaming. These technologies allow for precise sound placement, giving users a realistic audio experience that draws them into the action. Furthermore, the receiver includes a built-in equalizer, offering users the ability to customize their audio settings according to their preferences.

Another noteworthy feature of the JVC RX-7020VBK is its user-friendly interface. The receiver comes with an intuitive remote control that allows for easy navigation through menus and settings, making it accessible for all users, regardless of their technical expertise. Additionally, the receiver has a sleek and modern design that blends seamlessly with any home décor.

The JVC RX-7020VBK also incorporates advanced protection circuits to safeguard against damage from overheating and overloads, ensuring longevity and reliability. With its combination of power, versatility, and user-friendly features, the JVC RX-7020VBK stands out as an excellent choice for those looking to elevate their audio experience at home. Its balance of performance and technological advancements makes it suitable for both dedicated audiophiles and casual users alike.
Top Page Image Contents