Huffy AR64S-H manual Align dimple of top pole section

3.Identify pole sections.

5

Identification Sticker

4

6

While maintaining alignment, bounce middle pole section (5) into top section (4)

4.using a wood scrap as shown until the top pole no longer moves toward the pole

identification sticker on the middle pole.

IMPORTANT!		CAUTION!
		THE IDENTIFICATION STICKER IS
Align dimple of top pole section (4)		LOCATED 5" FROM THE END OF
		THE POLE. WHEN PROPERLY
		POUNDED TOGETHER, THE POLE
into trough of middle pole section (5)		MINIMUM OVERLAP, LEAVING 1-
as shown.		SECTIONS SHOULD HAVE A 3-1/2"
		POLE AND THE IDENTIFICATION
		1/2" BETWEEN THE OVERLAPPING
		STICKER.
pole em	ID
	STICKER
5"		5
	pole middle
	1-1/2"
	DIMPLE	4
	HOLE	WOOD SCRAP
		(NOT SUPPLIED)

ID# M661144 02/06 14