Huffy 7900 manual Safety Instructions

Page 3

SAFETY INSTRUCTIONS

FAILURE TO FOLLOW THESE SAFETY INSTRUCTIONS MAY RESULT IN SERIOUS INJURY,

PROPERTY DAMAGE AND WILL VOID WARRANTY.

Owner must ensure that all players know and follow these rules for safe operation of the system.

To ensure safety, do not attempt to assemble this system without following the instructions carefully. Proper and complete assembly, use and supervision is essential for proper operation and to reduce the risk of accident or injury. A high probability of serious injury exists if this system is not installed, maintained, and operated properly.

If using a ladder during assembly, use extreme caution.

Check base regularly for leakage. Slow leaks could cause the system to tip over unexpectedly

Seat the pole sections properly (if applicable). Failure to do so could allow the pole sections to seperate during play and/or during transport of the system.

Climate, corrosion or misuse could result in system failure.

If technical assistance is required, contact Huffy Sports.

Minimum operational height is 6’6” (1.98m) to the bottom of backboard.

Most injuries are caused by misuse and/or not following instructions.

Use caution when using this unit.

NOTICE TO ASSEMBLERS

ALL Huffy Sports basketball Systems, including those used for DISPLAYS, MUST be assembled and ballasted with sand or water according to instructions. Failure to follow instructions could result in SERIOUS INJURY. It is NOT acceptable to devise a makeshift weight system.

IMPORTANT!

Remove all contents from boxes.

Be sure to check inside pole sections; hardware and additional parts are packed inside.

3

03/04

P/N 21447703

Image 3
Contents Portable Basketball System 21447703 03/04 Safety Instructions Front Back Qty Description Hardware Identifier Bolts & Screws Height Adjustment Before YOU Start Label Section a Assemble the PolesIdentification Sticker AND/OR Section B Assemble the BaseDo not Over Tighten 03/04 Install wheel assembly to base 8 using Socket Wrenches and Sockets 9/16 3/4 Section C Assemble the Elevator & Backboard21447703 03/04 FIG. a Face of Backboard 03/04 Tighten ALL Hardware from 8 After this Assembly is Completed 03/04 USE EYE Protection Section D Securing the System FIG.A Section E Install Front CoverInstall clips Section F NET InstallationInsert net into bottom of clip as shown Section G Apply Height and Moving Label Height AdjustmentSection H Height Adjustment Français Deutsch Español Arrière Warnung Consignes DE Sécurité Avis AUX Personnes Chargées DU Montage Liste DES Pièces Teileliste Lista DE Piezas Identification DES Pièces Boulons ET VIS Height Adjustment Remarque Remarque UND/ODER ET/OU Wichtig ¡IMPORTANTE Avertissement Warnung ¡ADVERTENCIA 03/04 2, 2 9/16 2 3/4 Page FIG. a ABB. a Face du panneau Korbwandvorderseite Cara del respaldo 21447703 03/04 Wichtig ¡IMPORTANTE 5020 03/04 Avertissement FIG.A ABB. a Installez les pinces Height Adjustment