Huffy 7900 manual Section a Assemble the Poles, Label

Page 9

SECTION A: ASSEMBLE THE POLES

1. Correctly identify each pole section. Poles have an identification sticker that will be used as a
reference point in the next step.	1

Pole Identification Sticker

3

2

WARNING	Pole Identification Sticker
LABEL

2. Align dimple of top pole with slot of middle pole. While maintaining alignment, bounce middle pole (2) into top pole section (1) using a wood scrap as shown until top pole no longer moves toward pole identification mark on middle pole.

	CAUTION!
	THE IDENTIFICATION STICKER IS
	LOCATED 5" FROM THE END OF
	THE POLE. WHEN PROPERLY
	POUNDED TOGETHER, THE POLE
	SECTIONS SHOULD HAVE A 3-1/2"
	MINIMUM OVERLAP, LEAVING 1-	Pole
	1/2" BETWEEN THE OVERLAPPING
	POLE AND THE IDENTIFICATION
	STICKER.	Identification
		Identification
IDENTIFICATION	2	Mark
STICKER
	pole middle
	5"
1
	2
IDENTIFICATION
STICKER
	pole middle

1-1/2"

1

2

1

WOOD SCRAP

(NOT SUPPLIED)

9

03/04

P/N 21447703

Image 9

Contents Portable Basketball System 21447703 03/04 Safety Instructions Front Back Qty Description Hardware Identifier Bolts & Screws Height Adjustment Before YOU Start Label Section a Assemble the PolesIdentification Sticker AND/OR Section B Assemble the BaseDo not Over Tighten 03/04 Install wheel assembly to base 8 using Socket Wrenches and Sockets 9/16 3/4 Section C Assemble the Elevator & Backboard21447703 03/04 FIG. a Face of Backboard 03/04 Tighten ALL Hardware from 8 After this Assembly is Completed 03/04 USE EYE Protection Section D Securing the System FIG.A Section E Install Front CoverInstall clips Section F NET InstallationInsert net into bottom of clip as shown Section G Apply Height and Moving Label Height AdjustmentSection H Height Adjustment Français Deutsch Español Arrière Warnung Consignes DE Sécurité Avis AUX Personnes Chargées DU Montage Liste DES Pièces Teileliste Lista DE Piezas Identification DES Pièces Boulons ET VIS Height Adjustment Remarque Remarque UND/ODER ET/OU Wichtig ¡IMPORTANTE Avertissement Warnung ¡ADVERTENCIA 03/04 2, 2 9/16 2 3/4 Page FIG. a ABB. a Face du panneau Korbwandvorderseite Cara del respaldo 21447703 03/04 Wichtig ¡IMPORTANTE 5020 03/04 Avertissement FIG.A ABB. a Installez les pinces Height Adjustment