SECTION
SECTION 2—ASSEMBLY
Assembling the Patient Lift
Assembling the Mast to the Base
NOTE: The mast assembly may be removed from the base for storage or transporting. The mast assembly MUST be properly secured to the base assembly before use.
NOTE: For this procedure, refer to
FIGURE 2.1.
1.Put the base on a level surface so all casters make contact with the floor.
2.Lock the rear casters (Detail “A”).
3.Remove the shoulder bolt, nut and washer, that secures the mast to the base.
4.Put the mast into the U‐shaped cut‐out in the base.
5.While supporting the mast, insert the shoulder bolt through the base, mast and washers.
6.Secure the mast in place with a nut.
DETAIL “A” -
LOCKING/UNLOCKING REAR CASTERS
Step Here | Step Here to |
to Lock | Unlock |
Locking
CasterLever
Washers
Shoulder
Bolt
Nut
Part No 1078988 | 11 | Electric Portable Patient Lift - |