Weider 831.159823 user manual

25.Route the Leg Press Cable (95) through the Left Leg (36) and the Left Upright (7) as shown. Wrap the Cable around a 3 1/2” Pulley (38). Attach the Pulley inside the Upright with a 3/8” x 2 3/4” Bolt (81), two 3/8” Washers (75), two 1/2” Spacers (34), and a 3/8” Nylon Locknut (70).

26.Wrap the Leg Press Cable (95) around a 3 1/2” Pulley (38). Attach the Pulley inside the bracket on the Left Top Frame (3) with a 3/8” x 2” Bolt (62) and a 3/8” Nylon Locknut (70).

27.Remove the preattached 3 1/2” Pulley (not shown) from the “U”-Bracket (85).

Attach the end of the Leg Press Cable (95) to the “U”-Bracket (85) with a 1/4” Washer (35) and a 1/4” Nylon Locknut (65).Note: Do not complete- ly tighten the Locknut; it should be threaded only two turns onto the end of the Cable, as shown in the inset drawing.

28.Locate the Butterfly Cable (46). Attach the Cable to the Pivot Bracket (48) on the Left Butterfly Arm (10) with an 5/16” x 1” Shoulder Bolt (78) and a 5/16” Nylon Locknut (71).

25
38		70
34
	75
75
34
7
95
81	36
26
3
		70
62
38
95
27
95
35
	95
65
85		65
28
	71
		46
10	48	78

13