Weider 831.159730 user manual Remove a Pro Pulley 26 from the bag labeled Pulley BAG

Page 16

35.Attach the loop on the end of the Low Pulley Cable (75) to the indicated hole in the Small Leg Lever (41) with a 3/8” x 2 3/4” Bolt (46), two 3/8” Flat Washers (48), and a 3/8” Nylon Jamnut (63).

36.Remove a Pro Pulley (26) from the bag labeled “PULLEY BAG 2”.

Identify the Press Cable (72). It is approximately 389 1/2” long and it has a ball on one end and a threaded shaft on the other. You will begin by attaching the end with the ball.

Wrap the Press Cable (72) around a Pro Pulley (26) in the direction shown. Attach the Pulley to the indi- cated hole in the Press Top Frame (9) with a 3/8” x

3 1/2” Bolt (56), a 3/8” Flat Washer (48), and a 3/8” Nylon Jamnut (63). Make sure the Cable is between the Pulley and the welded pin on the Press Top

37.Route the threaded end of the Press Cable (72) around the 3 1/2” Pulley (24) that is already mounted on the Top Frame (9).

38.Wrap the Press Cable (72) around a 3 1/2” Pulley (24) in the direction shown. Attach the Pulley to the indicat- ed hole in the Press Upright (2) with a 3/8” x 3 3/4” Bolt (59), a 3/8” Flat Washer (48) and a 3/8” Nylon Locknut (50). Make sure the Cable Trap is oriented as shown.

35

 

41

 

63

 

48

75

 

48

46

36

 

 

9

63

26

48

72

 

56

 

Pin

37

 

9

 

 

24

 

72

38

2

50

 

48

 

 

25

 

24

72

 

59

16

Image 16
Contents Model No Serial No SEARS, Roebuck and CO. Hoffman ESTATES, ILTable of Contents Important PrecautionsDimensions Before You BeginAssembly Four Stages of the Assembly ProcessFrame Assembly Locknuts yetPage Locknuts yet Nylon Locknuts yet Nylon Locknut the Leg Press Lever must pivot easilyGroove Pin Grooves Brackets Arm Assembly Locate and open the parts bag labeled ARM AssemblyCable Assembly Large Cable Trap is oriented as shownSmall Pulley Bracket is oriented exactly as shown Bracket is oriented as shown Pulley Plates are oriented as shownMake sure the Cable Trap is oriented as shown Page Remove a Pro Pulley 26 from the bag labeled Pulley BAG Cable Trap is oriented as shownRemove a Pro Pulley 26 from the bag labeled Pulley BAG Page Make sure the Cable Trap is oriented as shown Page Seat Assembly Locate and open the parts bag labeled Seat AssemblyMiscellaneous Assembly Leg Press Plate must be on the upper edgeWeider Cable Diagrams Press Cable Changing the Weight Setting AdjustmentAdjusting the Leg Press Plate Trouble-shooting and Maintenance Weight Resistance Chart High Arm Leg Butterfly Curl Ab PulleyPress Lbs Leg RaisePage Part Identification Chart-Model No R0800APart List-Model No Qty DescriptionExploded Drawing-Model No QUESTIONS? Model No