6.Press a 2” Square Inner Cap (28) half way into the top of the Front Leg (20). Press a 2” Square Inner Cap (28) into each end of the Small Leg Lever (41).
Attach the Bumper (40) to the indicated hole in the Front Leg (20) with a 1” Tap Screw (80).
Lubricate the 3/8” x 3 1/4” Bolt (62). Attach the Small Leg Lever (41) to the bracket on the Front Leg (20) with the Bolt and a 3/8” Nylon Jamnut (63). Do not overtighten the Nylon Jamnut; it must be easy to pivot the Leg Lever.
7.Press a 1” Square Inner Cap (98) into the small tube on the Press Upright (2).
Place the bracket on the lower end of the Press Upright (2) over the indicated 5/16” x 2 1/2” Carriage Bolts (92) in the Press Base (6). Hand tighten two 5/16” Nylon Locknuts (64) onto the Bolts. Do not tighten the Nylon Locknuts yet.
Place the bracket on the lower end of the Support Frame (3) over the indicated 3/8” x 2 1/2” Carriage Bolt (101) and the 3/8” x 4” Carriage Bolt (102) in the Press Base (6). Hand tighten a 3/8” Nylon Jamnut
(63)onto the 3/8” x 2 1/2” Carriage Bolt (101). Do not tighten the Nylon Jamnut yet.
Note: Do not thread a Jamnut onto the 3/8” x 4” Carriage Bolt (102) yet.
Attach the Support Frame (3) to the Press Upright (2) with two 5/16” x 2 1/2” Carriage Bolts (92) and two 5/16” Nylon Locknuts (64). Do not tighten the Nylon
Locknuts yet.
8.Press a 2” Square Inner Cap (28) into the Press Top Frame (9).
Attach the Press Top Frame (9) to the indicated bracket at the top of the Press Upright (2) with two 5/16” x 2 3/4” Bolts (89), a Support Plate with 3 1/2” center holes (93), and two 5/16” Nylon Locknuts (64).
6 | 63 | 28 | |
28 | |||
|
| ||
|
| 62 | |
41 | 40 |
| |
|
| ||
|
| 20 | |
| 80 |
| |
28 |
| Lubricate | |
|
| ||
7 |
|
| |
|
| 64 | |
| 92 |
| |
| 64 | 3 | |
| 2 |
| |
98 |
|
| |
|
| 63 | |
|
| 64 | |
|
| 102 | |
6 | 101 |
| |
| 92 |
| |
8 | 89 |
| |
|
| 28 | |
| 93 |
| |
9 |
|
| |
| 2 |
| |
|
| 64 | |
7 |
|
|