17. Using an M10 x 80mm Bolt (25), an M10 Washer | 17 |
| |
(9), and an M10 Nylon Locknut (21), secure a |
| ||
| 66 | ||
90mm Pulley (15) and a Cable Trap (66) to the | 15 | ||
upper hole in the Press Frame (17). Make sure |
| 25 | |
that the Cable Trap and the Pulley are oriented |
| ||
as shown. |
|
| |
|
| 9 | |
|
| 21 | |
|
| 17 | |
18. Locate the Short Cable (23). Lay the Short | 18 |
| |
Cable inside the bracket on the Base (4). Attach a |
| ||
|
| ||
90mm Pulley (15) inside the bracket with an M10 |
|
| |
x 45mm Bolt (12) and an M10 Nylon Locknut |
|
| |
(21). Be sure that the ball on the Cable is on |
| 15 | |
the indicated side of the bracket. |
|
| |
|
| 12 | |
| 4 | Ball | |
|
| ||
| 21 |
| |
| Bracket | 23 | |
|
| ||
19. Attach two 90mm Pulleys (15) and two Cable | 19 |
| |
Traps (66) to the Front Upright (42) with two M10 |
| ||
42 | 66 | ||
x 90mm Bolts (16), two M10 Washers (9), and | |||
| |||
two M10 Nylon Locknuts (21). Be sure that all |
| 16 | |
15 | |||
parts are oriented as shown. Do not tighten | |||
9 |
| ||
the Nylon Locknuts yet. |
| ||
|
| ||
| 21 | 15 | |
20. Route the Short Cable (23) around the 90mm | 20 | 42 | |
Pulley (15) attached to the lower hole in the Front | |||
| |||
42 | 15 | ||
Upright (42). See the inset drawing. Be sure | |||
that the Cable Trap (66) is turned to hold the | 15 | 16 | |
Cable in place and that the Cable is routed | |||
|
| ||
around the Pulley as shown. Tighten the M10 | 21 |
| |
Nylon Locknut (21) and the M10 x 90mm Bolt | 66 | ||
| |||
(16). | 23 | 23 | |
| |||
|
| Inset shows view | |
|
| from other side | |
| 11 |
| |