Weider WESY17011 user manual Cable Trap is positioned to hold the Cable in place

10.Wrap the Long Cable (58) around a “V”-Pulley

(6).Attach the “V”-Pulley and a Long Cable Trap

(50)to the indicated bracket on the Front Upright

(42)with an M10 x 60mm Bolt (7) and an M10 Nylon Locknut (21). Be sure that the Long

Cable Trap is positioned to hold the Cable in place.

11.Route the Long Cable (58) around a “V”-Pulley

(6).Attach the “V”-Pulley and a Long Cable Trap

(50)to the Left Arm (47) with an M10 x 60mm Bolt (7) and an M10 Nylon Locknut (21). Be sure that the Cable is in the groove of the Pulley and that the Long Cable Trap is positioned to hold the Cable in place.

12.Route the Long Cable (58) around a “V”-Pulley

(6). Attach the “V”-Pulley and the Long Cable Trap (50) to the Right Arm (48) with an M10 x 60mm Bolt (7) and an M10 Nylon Locknut (21).

Be sure that the Cable is in the groove of the “V”-Pulley and that a Long Cable Trap is turned to hold the Cable in place.

13.Refer to the inset drawing. Using an M8 x 115mm Bolt (64) and an M8 Nylon Locknut (3), attach the Pulley Bracket (20) to the indicated bracket on the Top Frame (55). Note: The Pulley

Bracket is pre-assembled with a 90mm Pulley (15) and a Cable Trap (66).

Route the Long Cable (58) around the 90mm Pulley (15) attached to the Pulley Bracket (20).

Be sure that the Cable is in the groove of the Pulley and that the Cable Trap (66) is turned to hold the Cable in place. Make sure that the M10 x 45mm Bolt (12), securing the Pulley and Cable Trap to the Pulley Bracket, is properly tight- ened and that the Pulley Bracket can pivot freely.

9

10		7
		6	50
			58
		21
		42
11			7
		6	50
		21	47
		58
12		7
		50	6
		58
		48	21
13		66
	20
	15	12
	58		55
			64
			66
			20
			3