28.Attach the Curl Pad (72) to the Curl Post (71) with two M6 x 16mm Screws (18).
28
18
72
71
29.Slide two Handgrips (31) onto the ends of the Lat Bar (54).
29
54
31
31
30.Make sure that all parts have been properly tightened. The use of all remaining parts will be explained in ADJUSTMENTS, beginning on the following page.
Before using the weight system, pull each cable a few times to make sure that the cables move smoothly over the pulleys. If one of the cables does not move smoothly, find and correct the problem. IMPORTANT: If the cables are not properly routed, they may be damaged when heavy weight is used. See the CABLE DIAGRAM on page 20 of this manual for proper cable routing. If there is any slack in the cables, you will need to remove it by tightening the cables. See
15