Weider WESY17011 user manual

Page 14

26.Rest the Seat Frame (36) on the indicated pin in the Front Upright (42). Attach the Seat Frame to the Front Upright with an M8 x 67mm Carriage Bolt (14) and the Seat Knob (40).

27.Press 19mm Round Inner Caps (34) into the ends of both Pad Tubes (28).

Insert one Pad Tube (28) into the Seat Frame (36). Slide a Foam Pad (30) onto each end of the Pad Tube.

Insert the other Pad Tube (28) into the Leg Lever (29). Slide a Foam Pad (30) onto each end of the Pad Tube.

26
40
36
14
Pin
42
27
36
30
34
28
34
30
29

14

Image 14

Contents Customer HOT Line QUESTIONS?Model No. WESY17011 Serial No Table of Contents Important Precautions Dimensions Before YOU BeginAssembly Make Assembly Easier for YourselfFrame Assembly Each Carriage Bolt. Do not tighten the Nylon Locknuts yetARM Assembly Tighten the Nylon Locknuts used in stepsCable Assembly Cable Trap is positioned to hold the Cable in place Bolt and the Nylon Locknut are tight Upright 42. See the inset drawing. Be sure Parts are oriented as shown. Do not tightenNylon Locknuts yet Inset shows viewInset shows view Seat Assembly Tighten the Nylon Locknut the Leg Lever Must pivot freelyPage Page Attaching and Removing the Seat AdjustmentAdding Weights to the Weight Carriage Attaching the LAT BAR to the LEG Lever Attaching the LEG Lever to the LOW Pulley StationAttaching the Curl PAD to the Seat Frame Lbs Weight Resistance ChartWeight on Press ARM Butterfly ARM LOW Pulley High Pulley LEG LeverTROUBLE-SHOOTING and Maintenance Tightening the CablesTOP View Cable DiagramLong Cable Long U-Bracket Short CablePage Part LIST-Model No. WESY17011 Qty DescriptionR0802B Part Identification CHART-WESY17011 Page 19mm Round Inner Cap 25mm Retainer Icon Health & FITNESS, INC., 1500 S W., LOGAN, UT Ordering Replacement PartsLimited Warranty