SEAT ASSEMBLY | 23 |
|
|
|
|
| |
23. Attach the Backrest (41) to the Front Upright (42) |
|
|
|
with two M6 x 63mm Screws (43) and two M6 |
|
|
|
Washers (10). |
|
|
|
|
| 42 |
|
|
|
| 41 |
| 43 10 |
|
|
24. Press a 38mm Square Inner Cap (32) into the | 24 |
|
|
Seat Frame (36). |
|
| |
|
|
| |
Insert an M6 x 50mm Carriage Bolt (38) into the |
|
| 13 |
|
|
| |
center hole in the Seat Plate (37). Attach the Seat |
|
|
|
Plate to the Seat (13) with two M6 x 16mm |
|
|
|
Screws (18). |
| 38 |
|
|
|
| |
Insert the M6 x 50mm Carriage Bolt (38) into the |
| 37 | 32 |
|
| ||
indicated hole in the Seat Frame (36). Tighten an |
|
| 18 |
M6 Nylon Locknut (2) with an M6 Washer (10) | 36 |
|
|
onto the Carriage Bolt. | 24 |
|
|
| 10 | 2 | |
Attach the other end of the Seat (13) to the Seat |
| ||
|
| ||
Frame (36) with an M6 Washer (10) and the M6 x |
|
|
|
50mm Screw (24). |
|
|
|
25. Press a 38mm Square Inner Cap (32) into the | 25 |
|
|
|
| 36 | |
Leg Lever (29). |
|
| |
|
|
| |
Lubricate the M8 x 67mm Bolt (61). Attach the |
|
| 3 |
Leg Lever (29) to the Seat Frame (36) with the |
|
| |
Bolt and an M8 Nylon Locknut (3). Do not over- | Lubricate |
| |
tighten the Nylon Locknut; the Leg Lever |
| 61 | 29 |
must pivot freely. |
| ||
Insert the two M10 Eyebolts (35) into the Leg |
| 35 | 9 |
|
| ||
| 21 | 21 | |
Lever (29) from the directions shown. Tighten an |
|
| |
| 9 |
| |
M10 Washer (9) and an M10 Nylon Locknut (21) |
|
| |
onto each Eyebolt. Note: Be sure the Eyebolts |
| 32 | 35 |
are positioned vertically on the Leg Lever. |
|
| |
|
|
| |
| 13 |
|
|