Weider WESY26331 user manual Be oriented to hold the Cable in the groove Pulley

20. Wrap the Butterfly Cable (89) around a 90mm	20
Pulley (82) as shown. Attach the Pulley and a
Cable Trap (80) to the bracket on the Leg Press				42
Upright (4) with an M10 x 48mm Bolt (50) and an
M10 Nylon Locknut (42). The Cable Trap must			82	4
be oriented to hold the Cable in the groove of
the Pulley.
	50	80
			89
21. Wrap the Butterfly Cable (89) under a 90mm	21
Pulley (82). Attach the Pulley and a Cable Trap		89
(80) between the single hole ends of two Pulley
Plates (31) with an M10 x 48mm Bolt (50) and the
M10 Nylon Locknut (42). Make sure that the
Cable Trap is positioned to hold the Cable in	42 82			50
place.				End with
				two holes
		80		should be
				down
		31
22. Wrap the Butterfly Cable (89) over a 90mm Pulley	22
(82) as shown. Attach the Pulley and a Cable
			80
Trap (80) to the other side of the bracket on the				50
Leg Press Upright (4) with an M10 x 48mm Bolt
(50) and an M10 Nylon Locknut (42). The Cable	42
Trap must be oriented to hold the Cable in the				89
			82
groove of the Pulley.
			4
23. Note: The Left Fly Arm (6) is shown removed	23
for easier part identification.
			51
Attach the Butterfly Cable (89) to the Left Fly Arm
(6) with an M8 x 22mm Shoulder Bolt (51) and an	89
M8 Nylon Locknut (40). Make sure the flat edge
of the Cable is against the Fly Arm.
	40			6
	Flat
	Edge
	12