Weider WESY26331 user manual Post

Page 19

47.Wrap the Low Cable (86) around a 90mm Pulley (82). Attach the Pulley and a Cable Trap (80) to the Ab Upright (1) with the M10 x 92mm Bolt (76) and an M10 Nylon Locknut (42). Make sure that the Cable Trap is in the indicated position.

48.Wrap the Low Cable (86) over a 90mm Pulley (82). Attach the Pulley and a Cable Trap (80) to the lowest hole in the set of Pulley Plates (31) with an M10 x 48mm Bolt (50) and an M10 Nylon Locknut (42). Make sure that the Cable Trap is turned to hold the Cable in place.

49.Wrap the Low Cable (86) under a 90mm Pulley (82). Attach the Pulley to the Ab Upright (1) with the M10 x 92mm Bolt (76), an M10 Washer (38), and an M10 Nylon Locknut (42). The ball on the

Cable must be on the indicated side of the Pulley. Make sure that the Cable and Pulley move smoothly and that the Cable is between the Pulley and the post.

47
	1
42	86
42
80
	82
	76
48
	31
	42
	50
	82
	80
86
49
	86
1
42
38	82
	82
	76
	Post

19

Image 19

Contents Model No. WESY26331 Serial No QUESTIONS?Customer HOT Line Table of Contents Important Precautions Decal1 Before YOU BeginMake Assembly Easier for Yourself AssemblyDo not tighten the Locknuts yet Frame AssemblyLocknuts yet Weights Tighten the Locknuts yet Assembly Ner Repeat this step with the Right Fly Arm Cable AssemblyCable Trap is positioned to hold the Cable Place Be oriented to hold the Cable in the groove PulleyLocknut 42. The Cable must be routed from Direction shown Identify the Rear Cable 87-this is the shortIdentify the Press Cable 88-this is Page Not tighten the Locknut until completing step Route the Press Cable 88 around the 90mm End with two Holes should Be down Post Nylon Locknut Locate and open the parts bag labeled Seat AssemblyM6 Nylon Locknut Changing the Weight Setting AdjustmentsAttaching the Accessories Attaching the LEG Lever to the LOW Pulley Station Adjusting the LEG Press PlateAttaching the AB Strap to the AB Pulley Station Attaching and Removing the SeatPlates Weight Resistance ChartTightening the Cables MaintenanceRear Cable 87 can be tightened in the same manner Cable Diagrams High Cable High Pulley-1 Weight Stack-5 Rear Cable Top Frame R0904A Part Identification CHART-Model No. WESY26331Page Qty Description Part LIST-Model No. WESY26331Exploded DRAWING-Model No. WESY26331 Limited Warranty Ordering Replacement PartsIcon Health & FITNESS, INC., 1500 S W., LOGAN, UT