Weider user manual Part Identification CHART-Model No. WESY26331, R0904A

Page 28

PART IDENTIFICATION CHART—Model No. WESY26331

R0904A

M6 x 63mm Machine Screw (64)

M6 Nylon Locknut (44)

M6 x 63mm Carriage Bolt (60)

M8 Nylon Locknut (40)

M8 x 63mm Bolt (39)

M10 Nylon Locknut (42)

M10 x 60mm Bolt (65)

M8 x 60mm Bolt (62)

M6 Washer (37)

M10 x 57mm Bolt (91)

M8 Washer (20)

M6 x 52mm Carriage Bolt (61)

M6 x 52mm Machine Screw (63)

M10 Washer (38)

M10 x 48mm Bolt (50)

M6 x 16mm Screw (59)

M8 x 45mm Bolt (68)

M5 x 25mm Tap Screw (72)

M8 x 22mm Shoulder Bolt (51)

Image 28

Contents Model No. WESY26331 Serial No QUESTIONS?Customer HOT Line Table of Contents Important Precautions Before YOU Begin Decal1Assembly Make Assembly Easier for YourselfDo not tighten the Locknuts yet Frame AssemblyLocknuts yet Weights Tighten the Locknuts yet Assembly Ner Cable Assembly Repeat this step with the Right Fly ArmBe oriented to hold the Cable in the groove Pulley Cable Trap is positioned to hold the Cable PlaceIdentify the Rear Cable 87-this is the short Locknut 42. The Cable must be routed from Direction shownIdentify the Press Cable 88-this is Page Not tighten the Locknut until completing step Route the Press Cable 88 around the 90mm End with two Holes should Be down Post Locate and open the parts bag labeled Seat Assembly Nylon LocknutM6 Nylon Locknut Changing the Weight Setting AdjustmentsAttaching the Accessories Adjusting the LEG Press Plate Attaching the AB Strap to the AB Pulley StationAttaching and Removing the Seat Attaching the LEG Lever to the LOW Pulley StationWeight Resistance Chart PlatesTightening the Cables MaintenanceRear Cable 87 can be tightened in the same manner Cable Diagrams High Cable High Pulley-1 Weight Stack-5 Rear Cable Top Frame Part Identification CHART-Model No. WESY26331 R0904APage Part LIST-Model No. WESY26331 Qty DescriptionExploded DRAWING-Model No. WESY26331 Limited Warranty Ordering Replacement PartsIcon Health & FITNESS, INC., 1500 S W., LOGAN, UT