Weider WESY26331 user manual Identify the Rear Cable 87-this is the short

24. Identify the Rear Cable (87)—this is the short-	24
est Cable. Remove the M8 x 69mm Shoulder
Bolt (43) from the Top Frame (2). Loosen the indi-		43		2
cated M8 Nylon Locknut (40).			87
				40
Attach the Rear Cable to the Top Frame with the		Loosen–40
M8 x 69mm Shoulder Bolt (43) and an M8 Nylon
Locknut (40). Make sure the flat edge of the
Cable is against the Top Frame.
Retighten the indicated M8 Nylon Locknut (40).
		Flat
		Edge
25. See the inset drawing. Wrap the Rear Cable	25
(87) under a 90mm Pulley (82). Attach the Pulley
and a Cable Trap (80) to the upper hole in a
Large “U”-bracket (84) with an M10 x 48mm Bolt
(50) and an M10 Nylon Locknut (42). Make sure	87
that the Cable is in the groove of the Pulley
and that the Cable and Pulley move smoothly.
	80	82
	42	50
	84
26. Wrap the Rear Cable (87) around a 90mm Pulley	26			2
(82). Attach the Pulley to the Top Frame (2) with
			42
an M10 x 48mm Bolt (50) and an M10 Nylon				50
Locknut (42). The Cable must be routed from
the direction shown.
				82
				87
27. Attach the Rear Cable (87) to a Small “U”-bracket	27
(32) with an M8 Nylon Locknut (40) and an M8				87
Washer (20). Do not completely tighten the
			32	40
Locknut; it should be threaded onto the end
			68
of the Cable so that two threads show past
the Locknut (see the inset drawing).				20
Attach the Small “U”-bracket (32) to the indicated				40
				25
Weight Tube (25) with an M8 x 45mm Bolt (68)
		87
and an M8 Nylon Locknut (40).	32
		20
		40
	13