Weider WESY26331 user manual Tighten the Locknuts yet

Page 8

8.	Lubricate the insides of the indicated holes in the	8
	Top Weights (24) with the included grease. Slide	8
	Top Weights (24) with the included grease. Slide
	a Top Weight onto each set of Weight Guides
	(23).
				23
				24	Lubricate
					Lubricate
					23
		Lubricate
9.	Attach the Top Frame (2) to the Ab Upright (1)	9
	with two M8 x 67mm Bolts (55), two M8 Washers	9			55
	with two M8 x 67mm Bolts (55), two M8 Washers				55
	(20), and two M8 Nylon Locknuts (40). Do not
	tighten the Locknuts yet.	55	20
		55
	Attach the Butterfly Frame (3) to the Leg Press	20			3
	Upright (4) with two M8 x 67mm Bolts (55), two	20			3
	M8 Washers (20), and two M8 Nylon Locknuts	2
	(40). Do not tighten the Locknuts yet.
		1	40	40	4
10.	Attach the upper ends of one set of Weight	10
	Guides (23) to the Top Frame (2) with an M8 x	10			69
	Guides (23) to the Top Frame (2) with an M8 x		40		69
	152mm Bolt (67), two 13mm x 19mm Spacers		40
	(69), and an M8 Nylon Locknut (40).	69			23
		69			23
	Attach the upper ends of the other set of	40			67
	Attach the upper ends of the other set of				67
	Weight Guides (23) to the Top Frame (2) in the	2
	same manner.	2
	same manner.
	Tighten the M8 Nylon Locknuts (40) used in		67
	steps 1–10.		67
	steps 1–10.
			23
		8

Image 8

Contents Customer HOT Line QUESTIONS?Model No. WESY26331 Serial No Table of Contents Important Precautions Before YOU Begin Decal1Assembly Make Assembly Easier for YourselfLocknuts yet Frame AssemblyDo not tighten the Locknuts yet Weights Tighten the Locknuts yet Assembly Ner Cable Assembly Repeat this step with the Right Fly ArmBe oriented to hold the Cable in the groove Pulley Cable Trap is positioned to hold the Cable PlaceIdentify the Rear Cable 87-this is the short Locknut 42. The Cable must be routed from Direction shownIdentify the Press Cable 88-this is Page Not tighten the Locknut until completing step Route the Press Cable 88 around the 90mm End with two Holes should Be down Post Locate and open the parts bag labeled Seat Assembly Nylon LocknutM6 Nylon Locknut Attaching the Accessories AdjustmentsChanging the Weight Setting Adjusting the LEG Press Plate Attaching the AB Strap to the AB Pulley StationAttaching and Removing the Seat Attaching the LEG Lever to the LOW Pulley StationWeight Resistance Chart PlatesRear Cable 87 can be tightened in the same manner MaintenanceTightening the Cables Cable Diagrams High Cable High Pulley-1 Weight Stack-5 Rear Cable Top Frame Part Identification CHART-Model No. WESY26331 R0904APage Part LIST-Model No. WESY26331 Qty DescriptionExploded DRAWING-Model No. WESY26331 Icon Health & FITNESS, INC., 1500 S W., LOGAN, UT Ordering Replacement PartsLimited Warranty