W983 Stacker/W863 Dryer Operating Guide
Stacker Tips and Troubleshooting
Cleaning
The Stacker requires a clean environment, free from dust, airborne contaminants and moisture. Operator maintenance is limited to cleaning the belts with a
Smudged Addresses
You can lift or slide any of the hold down rollers or springs where heavily printed areas of your envelopes may be smudged by running under the rollers/springs. Lift the roller/spring slightly and turn knob to lock in place away from the conveyor belt.
NOTE: To assure the envelopes travel properly through the Stacker, they must pass under the rollers and springs.
Jams
If mailpieces jam in the Stacker, the circuit breaker switch will auto- matically shut the Stacker off. DO NOT press the power switch. With the Stacker off, clear the jam and any remaining mailpieces. Wait 1 to 2 minutes before pressing the circuit breaker switch. The Stacker will power back up automatically when you press the circuit breaker switch.
Fuse Replacement
CAUTION: Disconnect power before replacing fuses. Turn the power switch Off and unplug the power cord from the AC power receptacle. For continued protection against risk of fire, replace only with same type and rating of fuse.
If fuse replacement is required, turn the Stacker off, unplug the AC power cord from the outlet and replace the defective fuse with another
1.6amp fuse. Fuse locations are shown in the illustration below. If the blown fuse condition occurs again, call Pitney Bowes for service.
Fuses
20 | SV61228 Rev. A |
