12 SV61228 Rev. A
W983 Stacker/W863 Dryer Operating Guide
Adjust Media Stop
The media stop is adjusted so that mailpieces from the printer hit the
stop and drop flat onto the conveyor belt. There are two adjustments
on the media stop: height and depth.
Height Adjustment Knob
Depth
Scales
Depth
Knobs
To adjust the dis tance:
1 Unlock wheels if they are locked.
2 Move the Stacker to the rec om mend ed dis tance from the printer
output roller and lock the wheels. Refer to tables and graphs on
pages 15-19 to determine the value.
To adjust the height:
• Loosen the knob on the side of the media stop and slide the
plate up or down. For 1/16” thick ness, slide a sample mailpiece
un der the balls and lower the media stop to the point of contact
and then lock. For over 1/16” thickness, set the media stop
low enough so that mailpiece cannot get below the edge of the
media stop and then lock.
To adjust the depth:
• There is a scale on the media stop that is used to set up for
dif fer ent size mailpieces. Loosen the two knobs and set the
knobs to the desired value on the scale. Refer to tables and
graphs on pages 15-19 to determine the value. Tighten the
knobs when you are finished.
Stacker_Dryer Op Guide Book.indb 12Stacker_Dryer Op Guide Book.indb 12 3/30/2004 10:26:45 AM3/30/2004 10:26:45 AM