Weider WEBE96491 specs

20.Slide a Pulley Spacer (49) onto the welded bolt on the Right Top Frame (29).

Wrap the Cable (35) around a 3 1/2Ó Pulley (57) in the direction shown. Attach the Pulley and two Pulley Covers (31) to the welded bolt on the Right Top Frame (29) with an M10 Washer (6) and an M10 Nylon Locknut (11). The Pulley Covers must be ori- ented as shown in the inset drawing. Note that the wide tab is over the stress-point, where the Cable wraps around the Pulley. Use this orienta- tion of the Pulley Covers in the following assem- bly step as well.

21.Wrap the Cable (35) around a 3 1/2Ó Pulley (57) in the direction shown. Attach the Pulley and two Pulley Covers (31) to the indicated hole in the Right Top Frame (29) with an M10 x 123mm Bolt (43), a Pulley Spacer (49), two M10 Washers (6) and an M10 Nylon Locknut (11).

22.Press a 25mm Round Inner Cap (32) into the end of each Small Weight Rest (26). Insert the Small Weight Rests into one set of holes in the Uprights and turn them, so the locking clips snap into place around the Uprights.

Insert the Weight Rests (21) into the appropriate holes in the Uprights and turn them, so the locking clips snap into place around the Uprights.

11 6

57 35

Welded

Bolt

31 49

Wide Tab

Stress-point

on Cable

		31
		57
	21
		35
	43	6
	43	57
		57
		29
		49
		31
		31
		6
		11
	22
		32
		26
		32
	21
		26
		21